Service manual
Rev. 2.00
- 79 -
SRP-275
5-1-3 Lever-ribbon-feeder assy
Part name Assembly procedure
① Lever-ribbon feed
② Shaft-reduction B
③ Wave washer
④ Gear-re_B
⑤ Ring-e hole (ø2.5)
1. Caulk ② Shaft-reduction B on ① Lever-ribbon feed and then
grease ② Shaft-reduction B with HG-31S.
2. Insert ③ Wave washer to ② Shaft-reduction B and then grease
③ Wave washer with HG-31S.
3. Insert ④ Gear-re_B to ② Shaft-reduction B and then fasten ⑤
Ring-e hole (ø2.5) to ② Shaft-reduction B.
5
1
2
3
4
5-1-4 Lever-tension assy
Part name Assembly procedure
① Lever-tension belt
② Shaft-pulley
③ Pulley
④ Washer-plain (ø2.6)
1. Caulk ② Shaft-pulley on ① Lever-tension belt and then grease
② Shaft-pulley with HG-31S.
2. Insert ③ Pulley to ② Shaft-pulley and then fasten ④ Washer-
plain (ø2.6) to ② Shaft-pulley.
<Check point>
Check ③ Pulley to rotate smoothly.
1
2
3
4