Service manual

Rev. 2.00
- 11 -
SRP-275
2-1-4 Paper Roll Installation
1) To prevent data loss, make sure that the printer is
not receiving data.
2) Open the rear cover by pushing the open button and
push the arrow mark back.
3) Remove the used paper roll core if there is one.
4) Insert the paper roll as shown.
5) Be sure to note the correct direction that the paper
should come off the paper roll.
6) Pull out small amount of paper as shown. Then close
the cover and tear off the extra paper by pulling it
toward the front of the printer.
CAUTION
Do not touch the auto cutter blade when you open rear cover.