Service manual
Rev. 2.00
- 109 -
SRP-275
5-5-4 Main-assembly C
Part name Assembly procedure
Bracket PCB ass’y①
(Sub-assembly D)
Screw② -taptite (M3×6)
Screw③ -taptite (M3×10) -3ea.
Harness④ -power
1. Tighten Harness-jumper cable to the side hole of Bracket PCB ①
ass’y with Screw② -taptite (M3×6).
2. Insert FPC-connector sub (16pin) to Bracket PCB ass’y① and
then tighten Bracket PCB ass’y① to Cover base with three ③
Screw-taptite (M3×10).
3.
Insert
Harness
④
-power
into the right front side hole of
Cover base
.
4. Insert the 2pin connector of Harness④ -power, the 6pin connector
of Harness-operation panel and the 2pin connector of Harness-
power in three connectors PCB-main ass’y.