User's Manual

User Manual
1. Press and hold the Capture Button for 2 seconds to power
on. Enable the Bluetooth on the mobile phone to start
searching and click “ITFIT Selfie P007” on the searched
device list. The green indicator will go off after successful
connection.
2. Go to Camera App mode and start to take selfies.
Take the remote control from the selfie stick for long-distance
photographing.
Press the Capture Button to take a photo or record a video (
under the REC mode).
Take the remote control from the selfie stick, push the rear
cover at the direction of the arrow, and take off the rear cover
for battery replacement.
1. In case of no operation within 3 minutes after Bluetooth
is connected, the selfie stick will automatically enter the
Sleep Mode. Press the Capture Button again to restore
connection. In the event of no operation after 6 hours in
the Sleep Mode, the selfie stick will automatically power off.
2. In case of low battery during the use of the selfie stick, the
indicator will turn red and flash. Please replace the battery
in a timely manner.
Product Description
Quick Guide
User Notes
Contents
1. Upper Fixator
2. Phone Holder
3. Lower Fixator
4. Rotational Axis
5. Extendable Stick
6. Remote Control Indicator
7. Capture Button
8. Tripod
5
4
6
7
2
3
8
1
Bluetooth Tripod Selfstick*1
User Manual*1
Bluetooth Tripod Selfstick
Remote Control
Unfold the tripod in the bottom, push the extendable
stick up and place the tripod on a flat surface.
Tripod
Press and hold the Capture Button for 3 seconds and
the green indicator will flash for 3 times before going off.
Power Off
Do not move the phone by force after it’s clamped in
case of damage to the phone shell.
Preventive Measure
2. Pull the upper fixator up
to snap the phone into
the holder.
1. Insert the phone into the
lower fixator slantwise.
1. Hold the phone with one
hand and pull the upper
fixator up.
2. Slide the phone out.
1. Extend the selfie stick to the
proper length and start to take
selfies.
Barrier-free Operation within
10 Meters
2. Unfold the tripod, push the
extendable stick up and place
the tripod on a flat surface. Start
to take selfies.
User Manual
Reminders
1. Watch your hands during use.
2. The product is not designed for children under 14 years old.
Do not swallow it.
3. Do not dismantle or modify the product.
4. Do not store the product in a humid environment.
5. Keep the product away from heat sources.
6. Do not expose the product to water or other liquids in case
of damage.
Warnings
How to Install it
How to Replace Battery Product Specifications
How to Take off the Phone
How to Use it
EN EN EN
EN EN EN
Bluetooth Tripod Selfstick
3V
China
142g
ABS+ Aluminum Alloy
207mm
75mAh
Product Name
Model No
Rated Voltage
Place of Origin
Weight
Materials
Length of Storage
Battery Capacity
-20℃~+53℃
Product operating
temperature range
The device has been evaluated to meet general RF exposure
requirement, The device can be used in portable exposure
condition without restriction Federal Communication
Commission (FCC) Radiation Exposure Statement Power is so
low that no RF exposure calculation is needed.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or changes
to this equipment. Such modifications or changes could void the
user’s authority to operate the equipment.
Made in China
Manufacturer:Winners' Sun Plastic & Electronics (Shenzhen)
Co., Ltd.
Address: 1/F-4/F of Factory 6 & 3/F of Factory 2, Detai Industrial
Park, 496 Huarong Road, Langkou Community, Dalang Sub-
district, Longhua District, Shenzhen Guangdong, China
Copyright@2020 ITFIT All rights reserved
Bluetooth Tripod Selfstick
ITFIT Selfie P007
成品尺寸：56*100mm
材质：80g书纸
折法：风琴折
FCC ID:2AVIA-ITFITP007