DE10x Headset Microphone Owner’s Manual
I f you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private household in the 28 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).
Introduction Congratulations on your purchase of the Samson DE10x Headset Microphone. The DE10x is a low profile, micro-miniature condenser headset microphone with a 3mm capsule. With its omnidirectional pick up pattern, the DE10x delivers linear off-axis frequency response, resulting in a clear and articulate sound perfect for house-of-worship, presentation, theater and fitness applications.
Features • • • • • • • • • 4 Headset microphone with 3mm miniature condenser mic capsule Low-profile, double ear design with adjustable frame and mic boom Ideal for live and broadcast vocal applications Omnidirectional pickup pattern 20Hz–20kHz frequency response Gold-plated connector, moisture-resistant coating and stainless steel mesh grille Dust and water/sweat-resistant rated at IP65 Includes four detachable adapter cables: 1/8” [3.
Fitting the DE10x Microphone he headset can be re-sized by sliding the T ear hooks to fit snug around your head. If the DE10x is loose and will not stay in place, slide the ear hook wires back for a tighter fit. Adjust the microphone position by holding the left ear hook wire and slide the boom forward or back. For optimum performance the microphone should be close to the skin and towards the corner of the mouth, approximately a half inch away.
Connector Cables The DE10x includes four cables with adapters for some of the most popular wireless microphone beltpack transmitters. 3.
Connector Cables The DE10x includes four cables with connectors to use with the most popular wireless body pack systems. To connect the cable to the headset: 1. Choose the right cable and connector that works with your wireless system. 2. Line the cable up to the threaded terminal on the back of the DE10x and screw the cable into the headset. Do not over tighten the cable. 3.
Mic Positioning Position the DE10x microphone element about 0.25” – 1” behind the corner of your mouth. Since the DE10x is an omnidirectional capsule, the end of the microphone does not need to be facing your mouth. To avoid breath noise and p-pops, do not place the microphone directly in front of your mouth. 8 If the microphone is too far away from your mouth you will need to increase the gain and reduce isolation. To minimize additional noise, do not locate the microphone tight against your cheek.
Specifications Element Back electret condenser Polar pattern Omnidirectional Frequency Response 20Hz–20KHz Sensitivity -45dBV/Pa @1kHz ±3dB Output impedance 2kΩ ±30% Maximum SPL 130dB Self-Noise 30dB(A) Dynamic Range 100dB Operating voltage 1.5–12V DC Cable: ø1.4mm*1.2m Weight: 13g Dimension: ø3mm Included Adapter Cables 1/8” (3.
Specifications 0° 45° 45° -5 -10 -15 -20 -25 dB 90° 90° 135° 135° 180° Polar Pattern dB 10 0 -10 -20 20 50 100 200 500 1000 2000 Frequency in Hz Frequency Response 10 5000 10000 20000 Hz
Samson Technologies Corp. 278-B Duffy Ave Hicksville, New York 11801 Phone: 1-800-3-SAMSON (1-800-372-6766) www.samsontech.