DE60x Headset Microphone Unidirectional Headset Microphone with Miniature Condenser Capsule Owner’s Manual
I f you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private household in the 28 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).
Introduction Congratulations on your purchase of the Samson DE60x Headset Microphone. The DE60x is a low profile, miniature condenser headset microphone with a 7.35mm flat capsule. With its unidirectional pickup pattern, the DE60x provides superb isolation, resulting in more gain before feedback with clear and articulate sound in live sound applications. The microphone has been specially treated with a water resistant coating providing extra protection from sweat and other moisture.
Features • • • • • • • • • 4 Headset microphone with 7.35mm miniature condenser mic capsule Low-profile, double ear design with adjustable frame Ideal for live and broadcast vocal applications Unidirectional (cardioid) pickup pattern 20Hz–20kHz frequency response Gold-plated connector, moisture-resistant coating and stainless steel mesh grille Dust and water/sweat-resistant rated at IP65 Includes four detachable adapter cables: 1/8” [3.
Fitting the DE60x Microphone he headset can be re-sized by sliding the T ear hooks to fit snug around your head. If the DE60x is loose and will not stay in place, slide the ear hook wires back for a tighter fit. Adjust the microphone position by holding the left ear hook wire and slide the boom forward or back. For optimum performance the microphone should be close to the skin and towards the corner of the mouth, approximately a half inch away.
Connector Cables The DE60x includes four cables with adapters for some of the most popular wireless microphone beltpack transmitters. 3.
Connector Cables To connect the cable to the headset: 1. Choose the right cable and connector that works with your wireless system. 2. Line the cable up to the threaded terminal on the back of the DE60x and screw the cable into the headset. Do not over tighten the cable. 3. Attach the included collar clip on the back of your shirt collar and run the mic wire from the DE60x headset to the wireless body pack. Leave enough cable to allow you to turn your head from side to side.
Mic Positioning The DE60x microphone is designed to be worn with the boom arm under the left ear. For optimal placement please follow the directions below: Position the DE60x microphone element about 0.25” – 1” behind the corner of your mouth. Since the DE60x is a unidirectional capsule, the low frequency characteristics will change depending on the position of the microphone from the sound source. To avoid breath noise and p-pops, do not place the microphone directly in front of your mouth.
Specifications Element Back electret condenser Capsule Dimension 7.35mm Polar pattern Cardioid (Unidirectional) Frequency Response 50Hz–18KHz Sensitivity -45dB 1V/Pa ±3dB at1kHz Output impedance 2kΩ ±30% SPL max 135 dB Operating voltage 0.8–5V DC Cable 4x ø1.4mm*1.2m Weight 13g Headset Dimensions (LxDxH) 5.3” x 4” x 2.7” / 135mm x 101.2mm x 68.2mm Included Adapter Cables 1/8” (3.
Specifications 0° 45° 45° -5 -10 -15 -20 -25 dB 90° 90° 135° 135° 180° Polar Pattern dB 10 0 -10 -20 20 50 100 200 500 1000 2000 Frequency in Hz Frequency Response 10 5000 10000 20000 Hz
Samson Technologies Corp. 278-B Duffy Ave Hicksville, New York 11801 Phone: 1-800-3-SAMSON (1-800-372-6766) www.samsontech.