User's Manual

ManualsBrandsSALUS North America ManualsElectronicsZigBee Zone Pump Wiring Center

AKL01PRF ZigBee Zone Pump Wiring Center

Wiring Guide

Fuse: 5A slow blow, 5x15mm (2AG)

Electrical Connections

Dry Contacts (rated 120VAC, max.2A)

XX Active Pump

120VAC Connections

AC Line In

Zone Pump Line Out (max. 1/6 HP)

N AC Neutral

Earth Ground

Issue Date: May 2017

For PDF Installation guide go to

www.salusinc.com

Technical Helpline 1-855-557-2587

Warning

• This product must be installed by qualified personnel and the installation must comply with the codes and regulations applicable to the

municipality where this product is installed. Failure to do so could lead to injury, death, or prosecution.

• Always disconnect the AC power before installing or working on AC power components.

LED Indicators

Name Color Meaning

Power

120 VAC power ON

Zone 1

Zone pump active

Network

Status

Searching for

network

Paired to a network

Zone Pump

The zone pump will be activated when

the thermostat calls for heat.

Auxiliary Output

XX: Contact closure when zone pump is ON.

Factory Default

To restore the wiring center to Factory Default,

press and hold the Pair button until the

Network Status LED turns off (~10 secs).

Note:

Restoring to Factory Default will remove

the wiring center from the network and delete

all associated devices.

WCID#

Zone LED Pattern:

short=1, long=3

Operational Summary

Wiring Center ID Number

Summary of content (2 pages)

PAGE 1
AKL01PRF ZigBee Zone Pump Wiring Center Wiring Guide LED Indicators Electrical Connections Dry Contacts (rated 120VAC, max.2A) XX Active Pump 120VAC Connections L N AC Line In Zone Pump Line Out (max. 1/6 HP) AC Neutral Earth Ground Color Meaning Power 120 VAC power ON Zone 1 Zone pump active Network Status Searching for network Paired to a network Fuse: 5A slow blow, 5x15mm (2AG) Wiring Center ID Number Operational Summary Zone Pump The zone pump will be the thermostat calls for heat.
PAGE 2
AKL01PRF ZigBee Zone Pump Wiring Center Installation Guide 1 2 3 4 Remove the plastic cover by unscrewing the 4 screws at the corners. Attach the back of the AKL01PRF to the wall or in a suitable location, using the included hardware. Disconnect the AC power to the AC wiring for the device. Wire the device to the AC power supply and zone pump using wiring appropriate for 120VAC. Connect the other terminals as appropriate to the other devices using proper wiring.