User's Manual

ManualsBrandsSalto Systems ManualsElectronicsBLE capable wall RFID card reader

FCC COMPLIANCE STATEMENTS

(FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW, UKCCLAYIQ,

UKCABXX,

UKCABXW, UKCWRDBK, UKCCB2, UKCAEB,

UKCEB7).

This device complies

with Part 15 of the

FCC Rules. Operation

is subject to the

following

two conditions:

(1)

this device may not cause harmful

interference,

and

(2)

this device must accept any

interference received, including interference

that may cause undesired

operation. Changes

modifications

not

expressly

approved by the party

responsible

for

compliance

could void the user’s

authority

to operate the equipment.

Note:

This equipment

has been tested and found to comply with the

limits

for a

Class

B digital device, pursuant to part 15 of the FCC Rules.

These limits

are

designed

to provide

reasonable

protection

against harmful interference

in a

residential installation.

This equipment generates,

uses, and can

radiate

radio

frequency energy

and, if not

installed

and used in accordance with the instructions may cause

harmful interference

radio

communications. However,

there is no

guarantee

that

interference

will not occur in a particular

installation.

If this

equipment

does cause

harmful interference

to radio or

television

reception, which can be

determined

by turning the

equipment

off and on, the user is

encouraged

to try to

correct the

interference

by one or more of the

following

measures:

•

Reorient

relocate

the

receiving

antenna.

•

Increase

the

separation

between the

equipment

and receiver.

•

Connect the

equipment

into an outlet on a circuit

different

from that to which the

receiver

is connected.

•

Consult the

dealer

or an

experienced radio/TV technician

for help.

FCC Radiation Exposure Statement:

“This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for t his transmitter must be

installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or

transmitter.”

CANADIAN COMPLIANCE STATEMENT

(IC: 10088A-AE9, 10088A-AE9W,

10088A-L90, 10088A-G90, 10088A-RPOE, 10088A-NRF,

10088A-A9XX,

10088A-A9XW, 10088A-CLAYIQ, 10088A-ABXX, 10088A-ABXW, 10088A-WRDBK, 10088A-CB2, 10088A-AEB,

10088A-EB7).

This device complies

with

Industry Canada licence-exempt RSS standard(s). Operation

is subject to the

following

two conditions: (1) this device

may not cause

harmful interference,

and

(2)

this device must accept any

interference received, including interference

that may cause undesired

operation. Changes

modifications

not

expressly

approved by the party

responsible

for

compliance

could void the user’s

authority

to operate the

equipment.

Le présent

appareil

est conforme aux CNR

d’Industrie Canada applicables

aux

appareils

radio

exempts

de licence.

L’exploitation

est

autorisée

aux

deux conditions suivantes: (1) l’appareil ne doit pas produire de

brouillage,

et (2)

l’utilisateur

l’appareil

doit accepter tout brouillage

radioélectrique

subi, même si le

brouillage

est

susceptible

d’en compromettre le fonctionnement.

Distance

between

10088A-CLAYIQ

and

human

body must be

higher

than 20cm.

Distance entre

10088A-CLAYIQ

et le corps humain doit être

supérieure

à 20 cm.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to ICES-003.

Exposure to Radio Frequency Radiation.

To comply with RSS 102 RF exposure compliance requirements, for mobile

configurations, a separation distance of at least 20 cm must be maintained between the

antenna of this device and all persons. This device must not be co-located or operating in conjunction with any other antenna or transmitter.

Pour se conformer aux exigences de conformité CNR 102 RF exposition, pour des

configurations mobiles, une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne de cet appareil et toutes les personnes. Cet

appareil ne doit pas être colocalisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.

EU COMPLIANCE STATEMENT

(Products:

All

SALTO Systems

S.L. products with

RFID/Wireless

capability)

EN Hereby, SALTO Systems S.L. (Arkotz Kalea (Pol.

Lanbarren),

9 – 20180

Oiartzun– Spain),

declares that this access control

equipment is in compliance with the

essential requirements

and other

relevant provisions

Directive

2014/53/EU

(RED)

and

2011/65/EU (RoHS).

You will be able to find a copy of the

original declaration

of conformity at the

following Internet

address:

http://www.saltosystems.com/certificate

ES Por medio de la

presente SALTO Systems

S.L.

(Arkotz Kalea (Pol. Lanbarren),

9 – 20180

Oiartzun– Spain) declara

que este equipo de

control de accesos cumple con los

requisitos esenciales

cualesquiera

otras

disposiciones

aplicables o

exigibles

de la Directiva

2014/53/UE

(RED)

2011/65/UE (RoHS).

Podrá encontrar una copia de la declaración de conformidad

original

en la

dirección de internet: http://www.saltosystems.com/certificate

FR Par la

présente SALTO Systems

S.L.

(Arkotz Kalea (Pol. Lanbarren),

9 – 20180

Oiartzun– Spain) déclare

que l’appareil équipement

pour le con trôle d’accès est conforme aux

exigences essentielles

et aux

autres dispositions

pertinentes de la

directive

2014/53/UE

(RED)

2011/65/UE (RoHS).

Vous pouvez

télécharger

une copie de la déclaration de conformité

originale

à travers l’adresse

suivante: http://www.saltosystems.com/certificate

Hiermit erklärt SALTO Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9-20180 Oiartzun-Spain) dass sich das Gerät Zutrittskontrollgeräte

Übereinstimmung

mit den

grundlegendenAnforderungen

und den

übrigen einschlägigen Bestimmungen derRichtlinie 2014/53/EU (RED)

befindet und 2011/65/EU (RoHS). Eine Kopie der originalen Konformitätserklärung finden Sie

auf

der folgenden

Internetseite:

http://www.saltosystems.com/certificate

NL Hierbij verklaart SALTO Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) dat het toestel

toegangscontroleapparatuur

overeenstemming

is met de

essentiële

eisen en de andere

relevante

bepalingen van richtlijn

2014/53/EU

(RED) en 2011/65/EU (RoHS).

U kunt een kopie van de

originele verklaring van overeenstemming vinden

op het volgende

internetadres: http://www.saltosystems.com/certificate

Summary of content (3 pages)

PAGE 1
FCC COMPLIANCE STATEMENTS (FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW, UKCCLAYIQ, UKCABXX, UKCABXW, UKCWRDBK, UKCCB2, UKCAEB, UKCEB7). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
PT A SALTO Systems S.L. declara que este equipamento de controlo de acessos está conforme os requisitos essenciais e outras disposições da Directiva 2014/53/UE (RED) e 2011/65/EU (RoHS). Poderá encontrar uma cópia da declaração de conformidade original na seguinte direcção de internet: http://www.saltosystems.com/certificate EU COMPLIANCE STATEMENT (Products: All SALTO Systems S.L. products without RFID/Wireless capability) EN Hereby, SALTO Systems S.L. (Arkotz Kalea (Pol.
PAGE 3
manipulations performed by anyone other than authorized SALTO dealers or personnel. Likewise, the warranty is also made null and void if the inner electromechanical structure is in any way manipulated (for instance, loosening the screws) by anyone other than SALTO personnel. SALTO Systems, C/Arkotz nº9 Pol. Lanbarren, Arkotz Kalea, 20180 Oiartzun, Spain. http://www.saltosystems.