Manual
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Ph: 1-800-624-5269 Int’l Ph: 323-846-6700
Fx: 1-800-624-5299 Int’l Fx:
323-846-6800
www.collection boxes.com engineering@collection boxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 01, 2/19/2013) Page 1 of 1
With its high quality design and construction, Salsbury’s 3400 series collection box will provide years of maintenance free service. Please read this
entire document before beginning installation.
WARNING: The collection box unit with installed pedestal must be mounted
to a surface of sufficient load bearing
strength. Attachment must be with fasteners that can adequately support the weight of the collection box unit and
pedestal from static and wind load conditions. Installing to a deficient load bearing surface and/or use of inadequate
fasteners could cause the pedestal and collection box unit to tip over possibly resulting in injury. See below for further
information.
Install Pedestal to Cabinet
1. Lay the collection box unit on its back to install pedestal to the
cabinet as shown below. Collection box unit is heavy, always
get assistance to lift and move.
2. Fasten pedestal to collection box bottom using four (4) 3/8” hex
bolts and 3/8” washers provided. For added security, fasten the
pedestal to collection box bottom using a 3/8” shear away bolt
provided in lieu of any one of the 3/8” hex bolts. Tighten the
hexagonal head of shear away bolt until it snaps off. Pedestal is
now not removable.
Install Collection Box Unit to Mounting Surface
1. Use provided template to mark location of pedestal base
anchors.
2. Install anchors (not provided). Use 1/2” diameter anchors of at
least 6 inches.
3. Place provided rubber pad over anchors, see below.
4. Place the collection box unit with installed pedestal over rubber
pad and anchors.
5. Fasten pedestal to mounting surface with appropriate hardware
(not provided).
Pedestal Collection Boxes – 3450/3475
Installation Instructions