Manual

Signature Series Plaques – 1400 Series
Surface & Lawn Mount Installation Instructions
Thank you for selecting Salsbury Industries’ 1400 series signature surface and lawn mount plaques. We are confident that the quality of the plaque
will prove to be a good investment. These instructions are intended to assist you in a typical installation.
Surface Installation
The back of the plaque has two keyhole brackets to enable surface
mounting without screw heads being visible on the front surface. A
template is provided with the plaque to accurately locate the holes for
the fasteners. Two flat-head screws are provided that fit the keyhole
bracket. If a different type of fastener is required, choose one that
has the same size and type head.
The fasteners should be first installed in the mounting surface such
that the head protrudes out approximately 1/8” from the surface. See
Illustration 1. The plaque should be positioned such that the larger
holes in the keyhole brackets fit over the screw heads and then
moved down to trap the screw heads in the smaller slots in the
keyhole brackets. See Illustration 2. Try the plaque on the fasteners
and adjust their protrusion to enable a snug fit of the plaque against
the mounting surface.
If a secure rigid mounting is desired, it will be necessary to drill
mounting holes through the plaque, countersink the front of the
holes, and mount with appropriate flat head fasteners. Choose the
drilled hole locations for the best appearance appropriate for the
shape and size of the plaque.
Lawn Installation
The back of the plaque has four holes that mate with the four holes in
the metal stake provided. Attach the stake to the back of the plague
with the screws provided, being careful not to overtighten the screws,
thereby stripping the threads in the hole. The stake flanges should
protrude outward. See Illustration 3.
Cleaning
Using a soft cloth or sponge, clean the plaque with liquid soap,
detergent, or diluted water-soluble household cleaners. Completely
remove residue of any cleaning products with water and dry with a
clean cloth.
Illustration 1
Illustration 2
Illustration 3
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.mailboxes.com engineering
@mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 03, 2/17/2010)