3.If an enclose vehicle must be used, remove gas Into an approved red fus! container. DO NOT siphon by mouth. 4.run engine to use up the fuse In the carburetor and fuel tank. Always run engine In swell ventilated area. 5.wipe away any spilled fuel from engine and earth auger, allow to dry. LONG TERM STORAGE If your earth auger will not be used for more than more month, prepare It for long torn storage. Step for long term storage 1.Add fuel stabilizer according to manufacturer’s Instruction. 2.
Preventing Carbon Monoxide Poisoning e Never run angle: sneaker try to ventilate engine exhaust indoors. Carbon monoxide can reach dangerous ravels very quickly. s Never run engine outdoors In a poorly ventilated area where the exhaust fumes may be trapped and not easily taken away.
MAINTENANCE AND STORAGE AUGER MAINTENANCE 1.The gear case has 4cz of grease Installed at the factory, It Is recommended that once a year the gear case be split and the grease level checked. Add grease only f label of grease Is below top of the gear. DO NOT OVER FILL 2. Keep all screws nuts and bolts tight. 3.For cold weather operation store the ult In a cool environment, transferring the unlit fro a warm to a cold place can cause the bulls up of harmful condensation. 4.
OPERATION STEPS FOR WORKING ON ENGINE OR AUGER 1.Tum off engine switch. 2.Disconnected the spark plug wire from the spark plug. 3.Securely place the disconnected spark plug wire away from the spark plug and any metal parts. 4. Roplace or repair the part on engine or auger. 5.Check all parts that were repaired or removed during repair, that they ars secure and fit correctly. NOTE: All repair parts must from factory, never replace parts that are not specifically designed for the engine or auger. 6.
9.To stop engine, push rocker switch to OFF position. WARM ENGINE START: 1.0pen gas cap vent screw all the way (counterclockwise). 2 Move choke lever to CHOKE or ON position. NOTE:CHOKE position Is defined by moving the chokes lever as far to the ON postilion as possible. 3. Continus with Step § Cold Engine Starting. AVOID INJURY! ALWAYS HANDLE FUEL IN A WELL VENTILATED AREA, OUTDOORS, AWAY FROM LAMES OR SPARKS. AVOID INJURY! DO NOT START ENGINE IF FUEL IS SPILLED. WIPE OFF EXCESS FUEL AND ALLOW TO DRY.
Filling Gas Tank engine and allow engine to completely cold before refilling the gas tank 2.Move to a well ventilated area, outdoors, away from flames and sparks. 3. Cloan debris from area around the gas cap. 4.Loosen gas cap slowly. Place the cap on a clean dry surface. 5.Carefully add fuel without splicing. 6.Do not fell gas tank completely full, allow space for fuel to expand. 7. Immedlately replace gas cap and tighten. Wipe off spied fuel and allow to dry before starting engine. NORMAL OPERATION 1.