Part # 007-6510-001 Quick-Start Guide SpeedStream® 6500 Residential Gateway
Step 1 > Install Line Filters Before you begin, Verify that the following items came with your DSL kit: Devices such as fax machines, caller ID boxes, or phones that share the same phone line as your DSL account require a line filter, which prevents noise from disrupting the DSL signal on the phone line. Filters can be in the form of a stand-alone line filter or a wall-mount filter.
Step 3 > Configure the Gateway Step 2 > Ethernet Installation If your PC has not been connected to a broadband modem or other network device, you will need to perform the PC configuration procedure below. Remember to restart each PC when finished. If your PC has been connected to a broadband modem or other network device, continue to the “Using the Wireless Connection” section below.
Step 4 > PC Configuration Procedures Macintosh Configuration PC Configuration In order to setup the SpeedStream® DSL Gateway, your PC must first be configured to obtain an IP address from a DHCP server. Follow the procedure below: In order to setup the SpeedStream® Modem, your computer must first be configured to obtain an IP address from a DHCP server. Note: The following procedures cover configuration of a PC running Windows® 2000 or XP.
Troubleshooting LED Off Green Blinking Green Red Blinking Red/Green Power - Power not applied Normal system operation N/A Flash write in progress - POST in progress - POST error occurred (if persistent) Ethernet - Power not applied - No link Normal Ethernet operation, Link okay User traffic flowing in either direction N/A N/A Wireless - Power not applied - No link Normal wireless operation, Link okay Wireless user traffic flowing in either direction N/A N/A DSL - Power not applied -
