User's Manual

ManualsBrandsSAGEMCOM BROADBAND ManualsComputers & AccessoriesCable Modem

Page 1

1. Introduction

This F@ST 3284u Cable Gateway is an Embedded Media Terminal Adapter (EMTA) which is CableLabs DOCSIS 3.0 and

PacketCable 1.5 compliant. It provides high-speed Internet access as well as cost-effective, toll-quality telephone voice and

fax/modem services over residential, commercial, and education subscribers on public and private networks via an existing

CATV infrastructure. F@ST 3284u offers high-speed LAN connectivity with 4 Gigabit Ethernet ports and one integrated

Wireless LAN access point compatible with IEEE 802.11a/b/g/n. The Wireless access point is operating on 2.4GHz band.

Package Contents

F@S T3284u Gateway x1

Ethernet Cable (RJ45) x1

Phone Cable (RJ11) x1

Quick Start Guide x1

Power Supply Unit x1

2. Hardware Connection

12 13 14 15

1 2 3 4 5 6

8 9

LED Power ON/OFF

LED Downstream - indicate receiving RF DS traffic

LED Upstream - indicate receiving RF US traffic

LED Internet ON/OFF

LED WiFi ON/OFF

LED Telephone Line 1

LED Telephone Line 2

WPS button with Blue LED.

Wireless ON/OFF button

RJ-11 Telephone port lines 1 and 2

Ethernet 10/100/1000 BaseT RJ-45 connector

Restore To Factory Defaults button

RF coaxial F-connector

Power plug

Power switch ON/OFF

USB port

User Manual

Summary of content (11 pages)

PAGE 1
F@ST 3284 u User Manual 1. Introduction This F@ST 3284u Cable Gateway is an Embedded Media Terminal Adapter (EMTA) which is CableLabs DOCSIS 3.0 and PacketCable 1.5 compliant. It provides high-speed Internet access as well as cost-effective, toll-quality telephone voice and fax/modem services over residential, commercial, and education subscribers on public and private networks via an existing CATV infrastructure.
PAGE 2
Wall Mounting The number of the screw: 2 pcs Direction for wall mounting: LED panel upward. Dimension for the screw: 5~7.5 mm There are 2 slots on the underside of the modem that can be used for wall mounting. You will need 2 suitable screws which screw diameter would be 5~7.5 mm to wall mount the Cable Gateway. Note: When wall mounting the unit, ensure that it is within reach of the power outlet. To wall mount the unit: 1.
PAGE 3
. Connecting the F@ST3284 Gateway to Your Computer Installation Procedure for Ethernet Interface Follow the steps below for proper installation: 1. Make sure your computer meets the system requirements. 2. Connect a coaxial cable to the wall plug 3. Connect a coaxial cable to the CABLE connector on the F@ST3284u and screw it at the bottom manually (do not force). Note: To speed up the registration process of F@ST3284u, the coaxial cable should be connected to the gateway prior to the power connector.
PAGE 4
. Wireless Connection Step 1 Step 3 • Under the gateway, on the label, note the reference of SSID and WPA wireless password. Step 2 o In this new Window, search for the SSID value and select it by double clicking on it. Step 4 o The computer asks for a password. It is the WPA wireless password. • Click on “Start” then on: o Network Connection o Wireless network connection o Once the password entered twice, press “Connection” button. WiFi Configuration is finished. 5.
PAGE 5
6. Precautions and Warnings z Before connecting and disconnecting cables, stop using the F@ST3284u, and then disconnect it from h t e power supply. Ensure that your hands are dry during operation. z Keep the F@ST3284u far from sources of heatand fire, such as a heater or a candle. z Do not block the openings on the F@ST3284u with any object.Reserve a minimum space of 10 cm around the F@ST3284u for heat dissipation. z Place the F@ST3284u on a stable surface in a cool and well-ventilated indoor area.
PAGE 6
Safety and Certifications Important Information about the Sagemcom F@ST3284u: Installation and Safe Usage Instructions: 1. Place the router in a horizontal orientation on a flat surface. 2. Connect the manufacturer supplied AC to DC power adapter. The F@ST3284u requires the use of a 12 VDC, 2000 mA power adapter. Only use a manufacturer supplied and approved power adapter and Ethernet cable. 3.
PAGE 7
Safety and Certifications Federal Communications Commission (FCC) Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 8
Safety and Certifications 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device produces radio frequency energy in the 2.
PAGE 9
Safety and Certifications Wall Mounting (Optional) While many users place their F@ST3284u product on their desk, it can be optionally wall mounted. The number of the screw: 2 pcs. Direction for wall mounting: LED panel upward. Dimension for the screw: 5~7.5 mm. There are 2 slots on the underside of the modem that can be used for wall mounting. You will need 2 suitable screws which screw diameter would be 5~7.5 mm to wall mount the F@ST3284u.
PAGE 10
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 11
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.