SAGA PRO SERIES STEREO POWER AMPLIFIER OPERATION MANUAL
INSTALLATION Use care in unpacking the amplifier, and be sure to save the carton and packing materials so that you can use them for moving, storing, or if you need to return the unit for service. Never place the unit in direct sunlight, in excessive heat or humidity, in front of heating supply vents or extremely dusty locations. Make all connections according to the instructions on the following pages.
1. Saga Pro Series Front Panel A: Power Switch “I”= on / “O”= off This switch powers the unit on and off. B: Power ON LED indicator This light indicates that the power is on. C: Ch A Input Level Control D: Ch B Input Level Control These controls adjust the input level for their respective channels. In Bridge Mono Mode, only channel A level control is used to adjust signal level. In Parallel Mode, both input level controls are used to adjust signal level for their respective amplifier channels.
2. Saga Pro Series Rear Panel J: Ch A Input connector Connect the input source using either the XLR or 1/4” TRS plugs. K: Ch B Input connector Connect the input source using either the XLR or 1/4” TRS plugs L: Input Mode switch Use this switch to change the amplifier mode from stereo, mono bridged, or parallel. M: Ground/Lift Selected switch The Ground Lift switch is useful to eliminate hum problems. The goal is the isolation of the signal ground from interference.
3.
4. Saga Pro Series Technical Specifications: Model SAG6000 SAG6002 SAG6003 Dimensions 2U 2U 3U 8 ohms Stereo Power 2x150W 2x350W 2x500W 4 ohms Stereo Power 2x250W 2x450W 2x800W 8 ohms Bridge Power 500W 900W 1600W Frequency Response 20Hz to 20KHz < +/-0.5dB THD <0.05% (1KHz) Input Impedance 10K ohms Input Level 0dB Signal/Noise >95dB Input insulation >82dB (1KHz) Power Supply 120 VAC ~ 60Hz NO Signal Compressor Weight 33.07 lbs YES 41.89 lbs 59.52 lbs Dimensions 18.