User Manual

WIRING INSTRUCTIONS

Detach the phoenix connector from the back of the volume control. Attach the speaker wires to the

connector block following the diagram below. Be sure to follow the polarity when connecting the

wires. Your 70V speaker should be connected to the +OUT and -OUT terminals. Your amp should

be connected to the +IN and -IN terminals. Each terminal will hold up to 16AWG stranded wire.

For larger wiring or residential applications, a small length of wire and a wire nut are recommended.

Once the proper wiring is inserted into each terminal, use a Phillips head screwdriver to secure the

wires in place. After all the wires are secured, restore the phoenix connector to the appropriate

position on the back of the volume control.

Side View

Top View

Amplier

INSTALLATION MEASUREMENTS

Use the chart below to ﬁnd the appropriate cut-out dimensions and depth requirements for your

volume control.

A B C

SAG0240

SAG0242 2½" (64mm)

2¾" (70mm)

1¾" (45mm)

1¾" (45mm)SAG0241

ModelModel

QUICK INSTALLATION GUIDE

For 10W, 35W, & 100W Stainless Steel Volume Control Wall Plates

ELITE SERIES

Elite

Phoenix

Connector

PAGE 1
Elite ELITE SERIES QUICK INSTALLATION GUIDE For 10W, 35W, & 100W Stainless Steel Volume Control Wall Plates WIRING INSTRUCTIONS Detach the phoenix connector from the back of the volume control. Attach the speaker wires to the connector block following the diagram below. Be sure to follow the polarity when connecting the wires. Your 70V speaker should be connected to the +OUT and -OUT terminals. Your amp should be connected to the +IN and -IN terminals. Each terminal will hold up to 16AWG stranded wire.