User's Manual

Page 1 Driveway Monitor 30078

Installation Instructions

Wireless Driveway Monitor

Model # 30078

v5-3

Installing Batteries in the Driveway Sensor:

1. Open the case of the driveway sensor by

unscrewing the top in a counterclockwise

direction.

2. Remove the battery holder from inside the

sensor case by lifting up. Insert two "C"

alkaline batteries (not included). Note the

positive and negative battery orientation.

The sensor will make a faint cricket sound

when activated.

3. If needed, lubricate the o-ring with a thin

coating of Vaseline. (Recommended every

time the batteries are changed.)

4. Close the case back together tightly. The

O-ring should provide a water resistant

seal.

Setting Up the

Driveway Monitor Receiver:

Plug the antenna into the red RCA jack on the

back of the receiver (the top jack). The an-

tenna should be vertical.

Plug the AC adapter into the power jack on

the back of the receiver (the bottom jack).

The receiver will beep and the alert light will

turn on red for 5 seconds - then come on

green.

Testing the System Prior to Installation

The sensor and receiver are factory set to a unique code. Before installing

the sensor outside, test the unit by rotating the driveway sensor (rotate the

sensor more than 5 feet away from the receiver). (If you listen carefully, you

will hear the sensor softly chirp like a cricket when the unit is transmitting a

signal.) The receiver will chime 2 times and the ALERT light will flash RED for

15 minutes.

PAGE 1
v5-3 Installation Instructions Wireless Driveway MonitorTM Model # 30078 Installing Batteries in the Driveway Sensor: 1. Open the case of the driveway sensor by unscrewing the top in a counterclockwise direction. 2. Remove the battery holder from inside the sensor case by lifting up. Insert two "C" alkaline batteries (not included). Note the positive and negative battery orientation. The sensor will make a faint cricket sound when activated. 3.
PAGE 2
If the receiver does not chime or the red ALERT light does not come on during this test - refer to the Trouble Shooting section of the Reference Guide. Mounting the Driveway Sensor: 1. The stake comes in three parts. Assemble the parts by pressing the cap onto the tube and pressing the tube onto the stake. The cap protects the top of the tube during hammering. 2. Pound the assembled stake into the ground on the side of the driveway using a regular hammer. Never hammer the stake with the sensor attached. 3.