Instructions / Assembly

PIECE QUANTITY

A 2X

B 1X

C 1X

Model # SEA8035

Part List and Hardware List

Product Dimensions : 23.2"W x 39.3"D x 38.1"H

BACK PART

SEAT PART

FOOT STEP

PICTURE

ARM PART ( RIGHT and LEFT )

CARE AND MAINTENANCE

Always use felt pads under all articles to prevent discoloration or softening of the

lacquer. Plastic and rubber bases on items can discolor wood. Wipe up spills

immediately and avoid common hazards such as hot dishes, harsh solvents and

abrasives. Cleaning should be done with a soft lint free cotton cloth dampened with

water or furniture polish. On highly used surfaces we recommend applying a quality

paste wax which should be used on a regular basis to provide additional protection

from sratches and spills. How often you apply the wax depends on how much wear

the furniture receives.

NOTICE

* Please make sure that you have all parts indicated before you begin assembly of

this item

* This item should be assembled on a soft surface to prevent scratching the finish

during assembly

* This item may require periodic tightening

DESCRIPTION

C 1X

D 1X

F 16X

G1 2X

G2 10

G3 4X

H 1X

BOLT JCBC 6 x 40

SEAT PART

FOOT STEP

BACK SUPPORT

WOODEN DOWEL

BOLT JCBC 6 x 70

L-KEY

BOLT JCBC 6 x 50

PAGE 1
CARE AND MAINTENANCE Always use felt pads under all articles to prevent discoloration or softening of the lacquer. Plastic and rubber bases on items can discolor wood. Wipe up spills immediately and avoid common hazards such as hot dishes, harsh solvents and abrasives. Cleaning should be done with a soft lint free cotton cloth dampened with water or furniture polish.
PAGE 2
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 10 minutes. Step 1 1. Take out all the packaging from the part of the chair. 2. Take A1 part to be joined with B, C part and screw them with the the Boltpart G2 of A2 and joined it to be one unit of the chair, 3. Take screw with the BOLT G2. Step 3 1.