Instructions / Assembly

1 / 3

CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

Assembly Instruction

ITEM#:LIT4461A

Care and Cleaning

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean

water, never a solvent

)

to wi

e the surface of the fixture.

,)p

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit

breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean

cloth(use clean water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth

to dust or wipe carefully

dust

wipe

carefully

Estimated Assembly Time:30 minutes

Part List and Hardware List

PIECE DESCRIPTION PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY

Lamp Body

Mounting Plate

Tubt w/ shade

Hex Nut

Spring Washer

Canopy Nut

Allen Wrench

Mounting Screw

Wire Nut

Bulb

Tubt w/ shade

1 / 3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. ITEM#:LIT4461A Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water,, never a solvent)to ) wipe p the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 Unpack all parts from cartons carefully. Separate the Mounting Plate(A) from the Lamp Body(B) by removing the Canopy Nut(C) anticlockwise. Step 2 Insert each Tube w/shade(F,G,H) through the hole of the canopy of the Lamp Body(B). Place Spring Washer(E) onto each threaded nipple of the tube, fix each tube in place by turning the Hex Nut(D) with Allen Wrench(I) clockwise till tight as diagram. Step 3 Insert the J-box wires through the center opening of Mounting Plate (A).
PAGE 3
Grounding Instructions: a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector. b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding screw on mounting bracket. Tighten ground screw.