Installation & Assembly

®
SOLEA IS A REGISTERED TRADEMARK OF SAFAVIEH INTL LLC
FOR HELP WITH THIS PRODUCT, PLEASE GO TO SAFAVIEH.COM / CONTACT
40 HARBOR PARK DRIVE NORTH, PORT WASHINGTON, NY11050
Recommended Hardware Not Included
Under Mount Basin Installation
(1) Using the template (B) as a guide, mark the four hole locations for the mounting
hardware on the countertop.
(2) Using a 5/16 in. diamond bit, drill a 1/2 in. deep hole in each location.
(3) Clean the holes and apply quick set epoxy.
(4) Place one threaded knurl (BB) into each hole, and allow to cure for the amount of
time required according to the epoxy manufacturer's directions.
(1) Make sure the surface to be sealed is clean, dry, soap free, oil free, and grease
free.
(2) Apply a continuous bead of quality sealant around the top side of the sink (A) rim
near the edge.
(1) With the countertop positioned upside-down, center the sink (A) over the cutout.
(2) Firmly press the sink (A) onto the countertop, and immediately wipe off excess
sealant.
(3) Attach the undermount clips (AA) to the threaded knurl (BB) in the countertop
using the machine screws (CC) and washers (DD) to hold sink (A) in place.
(4) Allow the sealant to set for 30 minutes before proceeding.
(5) Flip the countertop right-side up, and install it onto the cabinet.
Step 3 : Mounting the sink
Step 2 : Applying the sealant
Step 1
Step 2
Step 3
Installation
Step 1 : Installing the anchors
NOTE: It is recommended that installation be performed by professional or contractor.
NOTE: It is recommended to practice the proper positioning two or three times
before applying sealant.
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: Handle with care. Vitreous Chinaware fragile with sharp edges if bronken.
NOTE:Pictures may not exactly define contour of china and components. Hardware not shown to actual size.
Part Description Quantity Part Description Quantity
AA Undermount clips 4 CC Machine screw 4
BB Threaded knurl 4 DD Washer 4