Installation & Assembly

Above Counter Basin Installation
1. Prepare countertop by making a cutout in the counter top using the supplied cutout template.
2. Make sure you leave enough room in between the wall and the vessel for faucet placement
3. Put a little bit of sealant or plumbers putty on the bottom side of vessel, this is to keep the vessel from turning or moving
once drain is installed.
4. Line up the cutout in the countertop and the drain hole in the vessel. Place the vessel on the countertop and press firmly.
5. Install Drain, Trap and Faucet according to manufactures specifications.
Installation
Tools you may be need:
Tape Measure PencilDrill
Plumber’s Putty
or Caulking
Note: Sink style, shape and cutout may vary from the actual product. This document is for instructional purposes only.
Lavatory
Counter Top
Apply a small
amount of plumbers
putty or sealant to
this area
Figure A
Lavatory
Figure B
• DO NOT OVERTIGHTEN DRAIN. Overtightening of the drain can damage your basin.
• DO NOT clean the basin with Detergents, Acid, Abrasives, Harsh Cleaners or a cloth with a coarse surface.
This is good advice for any plumbing fixture regardless of material.
• DO NOT leave any cleaning agents other than water on your basin
• DO NOT allow your basin to unnecessarily encounter other solid objects.
• DO clean your basin. Wipe with a damp cloth and dry with a soft cloth. If necessary, a general mild soap and
water solution can be used.
CARE AND CLEANING