Instructions / Assembly

ITEM#: FLU4008A

Care and Cleaning

Estimated Assembly Time:30 minutes

Part List and Hardware List

CAUTION: Read instruction carefully and turn electricity off at main circuit

breaker panel before beginning installation.

Assembly Instruction

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water,

never a solvent) to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit

breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean

cloth(use clean water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth

to dust or wipe carefully.

1/3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. ITEM#: FLU4008A Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent) to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 Attach the Mounting Plate (B) to the junction box using the Outlet Box Screw (D) on the ceiling wall. Step 2 Thread Stem (I) to the Fixture Body(N), then thread the Canopy (G) to the Stem (I). Step 3 Using the Wire Nut (A) connected the positive electrode and the negative pole of the fixture body carefully into the positive electrode and the negative pole in junction box.
PAGE 3
*Note: When parallel wire(SPTI&SPTII)is used. The neutral wire is square shaped and ridged and the hot wire will be round in shape and smooth.(See illustration on left) Grounding Instructions: a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.