Instructions / Assembly

CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

ITEM#:CHA4005A

Care and Cleaning

Estimated Assembly Time: 30 minutes

Part List and Hardware List

Assembly Instruction

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never

a solvent) to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker

or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth(use clean

water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth to

dust or wipe carefully.

1/3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. ITEM#:CHA4005A Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent) to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 Unpack all parts from carton carefully. Place the Canopy (H) onto the Hanging Loop (I) Screw the Nipple (F) into the threaded portion of the Hanging Loop (I) and fix it by turning the Canopy Nut (F) clockwise till tight. Attach the Closable Link (J) onto the Hanging Loop (I). Step 2 Thread the Stem (M) to top of the Fixture Body (R), and then thread the Fixture Loop (N) to the Stem (M). Attach the Closable Link (J) onto the Fixture Loop (N).
PAGE 3
*Note: When parallel wire(SPTI&SPTII)is used. The neutral wire is square shaped and ridged and the hot wire will be round in shape and smooth.(See illustration on left) Grounding Instructions: a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.