Instructions / Assembly

CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

ITEM#:CHA4003A

Care and Cleaning

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean

water, never a solvent)to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit

breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean

cloth(use clean water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth

to dust or wipe carefully.

Estimated Assembly Time:30 minutes

Part List and Hardware List

Assembly Instruction

Socket sleeve

Wire Nut

Mounting Plate

Mounting Screw

Bulb

PIECE

DESCRIPTION

PICTURE

QUANTITY

PIECE

DESCRIPTION

PICTURE

QUANTITY

Ground Screw

Canopy

Hanging Loop

Canopy Nut

Closable link/cap

Chain

Lamp Boby

Finial

Fixture Loop

1 / 3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. ITEM#:CHA4003A Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent)to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 G H Unpack all parts from cartons carefully. H Screw the Chain(J) to the Hanging Loop(F) and the Fixture Loop (I) with Closable link/cap (H) as diagram. I Step 2 Weave the 2 wire power cord and bare ground wire through every other loop to the top of chain(J),center holes of Hanging Loop(F)&Canopy(E)&Mounting Plate(B) as diagram. H G Insert the threaded tube of the Mounting Plate(B) into the center hole of the Hangling Loop(F),rotate the Mounting Plate(B) clockwise till tight.
PAGE 3
a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector. b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding screw on mounting bracket. Tighten ground screw.