User's Manual

44
Sabine Smart Spectrum
®
Wireless
© 2009 Sabine, Inc.
13.4. Remote Control Operation
13.4.1. Two Views, Two Sets of Controls
The default main screen ap-
pears as shown in figure 13c.
The top portion of the screen
(above the “Active Channels”
bar and two arrow buttons) is
the Command View, showing
details and allowing parameter
adjustments for a single re-
ceiver channel at a time.
The bottom portion (below
“Active Channels”) is the All
Channel View, capable of si-
multaneously showing the most
important (but less detailed) in-
formation for multiple channels.
Each audio (RF) channel in the
system has its own display box,
arranged in rows of eight chan-
nels each, organized in order
to correspond to the string of
receivers in the serial bus.
If you have 8 or fewer RF chan-
nels, both View Modes will fit on
your monitor. For more than 8
channels, there are quick short-
cuts for optimizing your display and switching and mixing View Modes:
• Click and drag the Active Channel bar to pull the All Channel View up or
down, partially or completely covering the Command View. You cursor
will change to a hand icon.
• Use the up/down arrows flanking “Active Channel” to scroll the rows dis
-
played in the space allocated to the All Channel View.
• Click on the Command View or All Channel View button in the upper left
menu bar (or use F2 and F3), to immediately change from one to the
other.
• To select a channel to edit in either view, left click on a channel in All
Channel View (indicated by a red border around the selected channel).
This displays the selected channel’s settings in the Command View. A
right mouse click on a single channel shown in the All Channel View pops
up a menu of parameters (see figure 13d). The value of the parameter
selected is displayed in the All Channel View for each RF channel, and
also pops up an adjustment screen for the selected channel. You can
review and compare settings on all channels, one parameter at a time,
and adjust any setting on any unit from the All Channel View.
• Parameter adjustments in the Command View can be made by clicking
and turning any knob; or by a right-clicking on a parameter to pop up an
adjustment window, and keying in a value.
13.4.2. Menus, Icons & Hot Keys
Quick access to the features described above, plus some additional software
control, is available from four pull-down menus (File, Select Receiver, Options,
and RF Scan) and five icons (FBX, Lock, Command View, All Channel View,
and RF Scan) at the top of the screen. The controls associated with the five
icons can also be accessed using function keys F2 through F6, respectively.
Figure 13e shows the location of the menus and icons, and describes associ-
ated controls which are accessed.
Remote Control Operation
Fig. 13d - All Channel View (after right-clicking
and selecting Ratio).