Simulator for RPG-7 1 Overview 1 Loudspeaker 5 RPG-7 Adapter 2 Firing signature 6 RPG-7 Fill 3 Laser aperture 7 SAAD Align 72 4 Battery 2 General 2.1 Laser safety Class 1 LASER Class 1 A Class 1 laser product does not present a hazard to the human eye. There are no associated hazard distances. The user is not at risk when directly exposed to the beam even at close range, however it is recommended that the user avoids direct exposure to the beam as a matter of good practice.
WARNING! Do not try to open the laser product. In case of failure, the laser product shall be sent to Saab Training Systems for service and repair. 2.2 Battery safety WARNING! Prevent Batteries from: • Damage • Short circuit • Exposure to temperatures above 70°C (158°F) • Being dismantled • Immersion in liquids For more information about how to handle Lithium Batteries in a safe way, see Safety Handling Instructions 8875 809470. 2.
Each time the soldier fires the simulator, the RPG-7 checks the status of the PDD to determine if the soldier is alive, wounded or killed. The soldier can not use the RPG-7 if the soldier has a kill or seriously wounded status and is therefore unable to handle the weapon. 3 Installation 3.1 Battery Installation 1. Make sure that the battery housing is clean and empty. Note! Make sure that the battery is charged. 2.
Note! The battery typically needs to be replaced every 100 hours. The replacement times are reduced in cold conditions. 3.2 Align the RPG-7 1. Put the SAAD Align 72 and the RPG-7 adapter together.
2. Attach the SAAD to the front end of the RPG-7. 3. Rotate the optics of the SAAD into the line of sight. A reticle pattern will be visible.
Note! The SAAD will turn off if a BIT error is detected, see Troubleshooting. The SAAD will also turn off after 3 minutes as a battery saving feature. Remove the SAAD and reinstall after 5 seconds. 4. The shooter should adopt a firing position and look through the sights. Adjust the reticle pattern to the sight by turning the two adjustment screws.
Correctly aligned: Note! If the alignment screws reach their end position, do not use excessive force, contact the Support team. 4 Operation 4.1 Fire the simulator Safety conditions WARNING! It is recommended to use ear protection when operating the simulator, because of high sound. 1. Follow the normal procedure for the actual weapon.
2. Make sure no other personnel are within the safety area. 3. Fire the simulator. 4. The firing signature will be simulated with a flashing LED in the front and a firing sound from the loudspeaker in the rear of the RPG-7. Note! There is a default reload time after firing. 4.2 Refill ammunition (option) Note! The RPG-7 is loaded with X number of ammo. "Out of ammo" sound is generated when the RPG-7 has run out of ammo. 1. Put the RPG-7 Fill and the RPG-7 adapter together.
2. Attach the RPG-7 Fill SAAD to the front end of the RPG7. 3. When the ammunition is loaded the RPG-7 generates a short tone.
5 Maintenance 5.
Symptom Cause Corrective action Firing OK but NO hit on the target RPG-7 is not correctly aligned Carry out the alignment procedure The target is too far away Out of range for RPG-7 Dirty Laser aperture Clean the Laser aperture Error Replace the simulator Increasing triple tone 5.2 Clean the equipment 1. Clean with water and a soft brush. 2. Wipe with dry cloth.
6 Regulatory Statements 6.1 FCC Certification The United States Federal Communication Commission (FCC) has established certain rules governing the use of electronic equipment. 6.2 Part15, Class B 1 This device is FCC certified, FCC ID: R4ARPG915 2 This device complies with Part 15 of FCC rules and operation and is subject to the following two conditions: 2.1 This device may not cause harmful interference, and 2.
FRENCH: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. IC RSS-GEN, Sec 7.1.
6.3 User Information WARNING! Any changes or modifications not expressly approved by the party responsible for compliance, namely Saab Defense and Security USA LLC, could void the user's authority to operate the equipment.