User's Manual

1. " LOW, MED, HI" buttons:

These three buttons are used to set the fan speed as follows:

LOW= Low speed MED= Medium speed HI= High speed

2. "OFF" button:

This button turns the fan off.

3. " 1H, 3H, 6H " button:

These three buttons are used to set the Fixed time as follows:

1H= ONE Fixed time 3H=THREE Fixed time 6H= SIX Fixed time

4. The "LIGHT" button turns the light ON or

OFF . Press and release the button to turn

the light ON or OFF

Notice : The changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance

requirements, no change to the antenna or the device is permitted. Any change to the

antenna or the device could result in the device exceeding the RF exposure

requirements and void user’s authority to operate the device.

PAGE 1
. " LOW, MED, HI" buttons: These three buttons are used to set the fan speed as follows: LOW= Low speed MED= Medium speed HI= High speed 2. "OFF" button: This button turns the fan off. 3. " 1H, 3H, 6H " button: These three buttons are used to set the Fixed time as follows: 1H= ONE Fixed time 3H=THREE Fixed time 6H= SIX Fixed time 4. The "LIGHT" button turns the light ON or OFF .
PAGE 2
The term “IC:” before the radio certification number only signifies that Industry Canada Technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.