User's Guide

ManualsBrandsS and C Electric ManualsElectronicsTripSaver Service Center Configurable Controller

July 21, 2014© S&C Electric Company

Instruction Sheet 461-506

S&C TripSaver® II Controller

TripSaver II Controller Module User Guide

Table of Contents

Section Page Section Page

Regulatory Information for FCC and IC ..........2

Hardware

Contents of Controller Module ....................3

Software

Download Software .............................4

Install Software ................................4

Launch Software ...............................4

Connect to a TripSaver II Controller Module ......5

Summary of content (8 pages)

PAGE 1
S&C TripSaver® II Controller TripSaver II Controller Module User Guide Table of Contents Section Page Regulatory Information for FCC and IC . . . . . . . . . . 2 Hardware Contents of Controller Module . . . . . . . . . . . . . . . . . . . . 3 Section Page Software Download Software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Install Software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 2
Regulatory Information for FCC and IC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference This device complies with Industry Canada licence-exempt RSS standard(s).
PAGE 3
Hardware Contents of TripSaver II Controller Module AC Adapter Power Outlet Plug Adapters USB Dongle Contoller Module This Manual S&C Instruction Sheet 461-506 3
PAGE 4
Software Download Software IntelliLink® TS-II controller module Setup Software is available for download only to customers who have purchased the Controller module. For each controller module purchased, the user is entitled to install and use S&C IntelliLink TS-II Controller module Setup Software on no more than two computers at a time. The latest software release is posted on the S&C Automation Customer Support Portal at www.sandc.com/support/ automation-customer-support-portal.asp.
PAGE 5
Connect to a TripSaver II Controller Module To connect to a TripSaver II Controller module to apply your new settings, follow the steps below. Step 1 Install USB Transceiver A USB Transceiver must be installed on your computer to communicate with a TripSaver II Controller Module. Insert the USB Transceiver into any USB port on your computer. The installation process should be automatic.
PAGE 6
Connect to a TripSaver II Controller Module (d) To verify that your TripSaver II Controller Module is powered up, place a magnet next to the controller module as shown in picture and observe the LCD screen. If the LCD screen begins to scroll, it indicates that the unit has been successfully powered up. Your setup, at the end of Step 2, should look like the picture on the right.
PAGE 7
Connect to a TripSaver II Controller Module Step 3 Obtain Transceiver ID A Transceiver ID unique to each TripSaver II Controller Module is needed to establish communications between your computer and the device. The ID consists of a 32-digit character string in the format of “0019C900.00020000. _ _ _ _ _ _ _ _ . _ _ _ _ _ _ _ _”. You must enter the ID in order to communicate with each TripSaver II Controller Module.
PAGE 8
Connect to a TripSaver II Controller Module Step 4 Connect to Device To connect to a TripSaver II Controller Module, select Connection > Connect to Device from the main menu or click the Connect to Device icon in the quick access toolbar. Make sure that the USB transceiver is already plugged into your computer. Next, a Transceiver ID Request dialog box will appear. Enter the Transceiver ID of the TripSaver II Controller Module you want to connect to, and click “OK” to connect.