Quick Installation Guide

Overview

RSK-UHF series

● Remove the cover at the lower

right corner of the back.

● Lock the UHF bracket tightly and securely.

● Connect the cable to the designated hole.

Note: Make sure you have successfully

connected the cable to the device.

● Lock the UHF module tightly and securely.

Note: Use a screwdriver for installation.

● Completion of installation

Note: To place the tablet evenly on a surface,

you can use the 4 rubber feet in the accessory box.

● Refer to the precautions below.

PAGE 1
Overview Lock the UHF bracket tightly and securely. Connect the cable to the designated hole. Note: Make sure you have successfully connected the cable to the device. ● Lock the UHF module tightly and securely. Note: Use a screwdriver for installation. ● ● RSK-UHF series Quick Installation Guide Overview ● Remove the cover at the lower right corner of the back. Completion of installation Note: To place the tablet evenly on a surface, you can use the 4 rubber feet in the accessory box.
PAGE 2
Overview This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users.