User Manual

ENGLISH
33
USER MANUAL
FCC AND OTHER INFORMATION
This equipment complies with Parts 68 of the FCC rules and the requirements adopted by the Adminis-
trative Council for Terminal Attachments (ACTA).
A plug and jack used to connect this equipment to the premises wiring and telephone network must
comply with applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant tele-
phone cord and modular plug is provided with this product. It is designed to be connected to a compat-
ible modular jack that is also compliant. See installation instructions for details.
An RJ11 jack should normally be used for connecting to a single line and an RJ14 jack for two lines.
See Installation Instructions in the user’s manual. This equipment may not be used with Coin Telephone
Lines or with Party Lines. If you have specially wired alarm dialing equipment connected to your
telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you
have questions about what will disable alarm equipment, consult your telephone company or a qualifi ed
installer.
This device complies with part 15 of the FCC rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) This device must accept any interfer-
ence received, including interference that may cause undesired operation. Privacy of communications
may not be ensured when using this phone.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try and correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet or on a circuit different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV technician for help.
FCC RF EXPOSURE WARNING
To insure the safety of users, the FCC has established criteria for the amount of radio frequency energy
various products may produce depending on their intended usage. This product has been tested and
found to comply with the FCC’s exposure criteria. For body worn operation, the FCC RF exposure
guidelines were also met when used with the accessories supplied or designed for this product. Use of
other accessories may not ensure compliance with FCC RF exposure guidelines and should be avoided.
Caution: To maintain compliance with the FCC’s RF exposure guidelines, the internal antennas used for
this mobile transmitter (Base unit) must provide a separation distance of at least 20 cm from all persons.
Base and Handset must not be co-located or operating in conjunction with any other antenna or transmitter.
Caution: Any changes or modifi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate this device.

Summary of content (4 pages)