Instructions / Assembly

May 14, 2019
Revision 01
Assembly Instructions
DIY Bench Ends
Read these instructions and general information to properly and safely
assemble the DIY Bench Ends.
RTS Companies Inc. | 1027 Industrial Place, St. Clements, Ontario N0B 2M0 | 1-800-663-2803
RTS Companies US, Inc. | 2900 Industrial Park Drive, Austinburg, Ohio 44010 | 1-888-641-3077
1. Tools: Drill, 10 Deck Screws (3.5”), 5
pieces of 2x4 lumber (up to 5’ long).
2. Lay one of the bench ends on the
ground and insert each of the pieces of
lumber into the slots. Make sure the wood
end.
3. Drill 1 screw into each section, through
the wood. Do not overtighten.
4. Place second bench end over pieces of
outer side of the bench end.
6. Grab your favourite beverage and enjoy
your view!
Contents:
2 bench ends
Required (not included):
5 equal le
ngths of 2x4 lumber (maximum 5’)
10 deck screws (3.5” long)
Drill
Method:
Please contact RTS Companies for any
questions or concerns
RTS Companies
1.800.663.2803 (CAN)
1.888.641.3077 (USA)
[e-mail]
5701-00100F-xx-xx
5. Drill 1 screw into each section, through
the wood. Do not overtighten.