® It’s Under Control® It’s Under Control T3-V+ Operation Guide Universal System Controller 70-210085-23 V1.
T3-V+ Universal System Controller Copyright © 2010 Remote Technologies Incorporated All rights reserved.
It’s Under Control® Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
T3-V+ Universal System Controller SAFETY SUGGESTIONS Read and Follow Instructions. Read all safety and operating instructions before operating the unit. Retain Instructions. Keep the safety and operating instructions for future reference. Heed Warnings. Adhere to all warnings on the unit and in the operating instructions. Heat. Keep the unit away from heat sources such as radiators, heat registers, stoves, etc., including amplifiers that produce heat. Do Not Open Battery Compartment.
It’s Under Control® Battery warnings GENERAL BATTERY WARNING: Rechargeable Lithium batteries can explode, catch fire, and/or cause burns if disassembled, punctured, cut, crushed, short circuited, incinerated, recharged, or exposed to water, fire, or high temperatures. DO NOT place loose batteries in a pocket, purse, or other receptacle containing metal objects, mix with used or other battery types, or store with hazardous or combustible materials.
T3-V+ Universal System Controller LIMITED WARRANTY Remote Technologies Incorporated warrants its products for a period of one (1) year (90 days only for included battery packs) from the date of purchase from Remote Technologies Incorporated or an authorized Remote Technologies Incorporated distributor.
It’s Under Control® Disclaimer All rights are reserved. No part of this document may be photocopied, reproduced, or translated without the prior written notice of Remote Technologies Incorporated. The information contained in this document is subject to change without notice. Remote Technologies Incorporated shall not be liable for errors or omissions contained herein or for consequential damages in connection with the furnishing, performance, or use of this guide.
T3-V+ Universal System Controller
It’s Under Control® Table of Contents Federal Communications Commission Notice................ 3 Safety Suggestions....................................................... 4 Battery Warnings......................................................... 5 Limited Warranty.......................................................... 6 Disclaimer ................................................................... 7 Table of Contents......................................................... 9 Chapter 1 - Welcome.........
T3-V+ 10 Universal System Controller
It’s Under Control® Chapter 1 | Welcome Thank you for purchasing the T3-V+ Universal System Controller. Representing the pinnacle of elegance, the T3-V+ is an extremely powerful controller wrapped in an easy-to-use, contemporary design. The third generation of the award-winning T3 system controller, the T3‑V+ is enhanced with a state-of-the-art dual RF platform, improved WiFi® performance and updated hard button configuration. Experience the eyepopping color of the 3.
T3-V+ Universal System Controller Chapter 1 | welcome IR COMPATIBILITY The T3-V+ and Integration Designer® software are compatible with infrared (IR) commands with carrier frequencies between 15kHz and 460kHz, as well as those commands that do not use a carrier. This covers virtually all of the remotes that exist to date.
It’s Under Control® Chapter 2 | introduction IMPORTANT NOTES Please read these important notes about the T3-V+: The T3-V+ should be placed in an area where it is around normal room temperature (between 60° F to 90° F). If the temperature is too hot, the display appears dim. If the temperature is too cold, the display appears dark and may respond slowly. Do not use sharp objects on the touchscreen. It is designed to operate with a touch of your finger. Do not let the T3-V+ get wet.
T3-V+ Universal System Controller Chapter 2 | introduction BATTERY AND DOCKING STATION The T3-V+ uses a Lithium-Ion rechargeable battery. This battery does not exhibit any type of “Memory Effect” from being charged too often. Since the T3-V+ can safely be charged after each use, a docking station is included for convenience. The T3-V+ Docking Station can be placed on a flat surface such as a shelf or table, or it can be mounted to a wall using the mounting holes on the back of the unit.
It’s Under Control® Chapter 2 | INTRODUCTION GETTING STARTED NOTE: The following steps for initial installation including removing the battery door should be performed by an authorized service center or trained installer only. Start by insuring the battery connector is inserted into the mating plug on the T3-V+. Make sure the connector is oriented properly before attempting to insert it. Next, turn the unit on by sliding the power switch into the “ON” position (toward the battery).
T3-V+ Universal System Controller Chapter 2 | INTRODUCTION REMOTE REFERENCE FRONT IR TRANSMISSION WINDOW LIGHT SENSOR TOUCHSCREEN DISPLAY “HOME” KEYPAD BUTTON CUSTOMIZABLE KEYPAD BUTTONS 3-WAY ROCKER SWITCH KEYPAD BUTTONS 16
It’s Under Control® Chapter 2 | Introduction BACK AUDIO SPEAKER LITHIUM-ION BATTERY PACK POWER SWITCH IMAGE REQUIRED USB PROGRAMMING PORT DOCKING STATION CONTACTS 17
T3-V+ Universal System Controller Chapter 2 | INTRODUCTION DOCKING STATION REFERENCE TOP CHARGE CONTACTS CHARGE LED BACK 2.5 in.
It’s Under Control® Chapter 2 | INTRODUCTION KEYCAP REPLACEMENT The T3-V+ kit includes a set of extra keycaps. They can be used instead of the keycaps that are pre-installed on the five customizable keypad buttons located just below the touchscreen. IMPORTANT NOTE: Do not attempt to replace any of the other button keycaps on the remote, as they are not designed to be removed.
T3-V+ Universal System Controller Chapter 2 | INTRODUCTION 20
It’s Under Control® Chapter 3 | operation PROGRAMMING THE T3-V+ The T3-V+ is programmed using Integration Designer® software. RTI dealers can download the software from: www.rticorp.com/dealers The required USB cable is included with the RTI IR-PRO dealer kit. THE TOUCHSCREEN DISPLAY The T3-V+ touchscreen display is organized into a series of pages. Normally each page contains objects (buttons, text, graphics, etc.) that are related in some way.
T3-V+ Universal System Controller Chapter 3 | operation THE CONTROL PANEL The Control Panel page can be displayed by first setting the T3-V+ power switch to the off position, and then Pressing and holding the touchscreen while sliding the power switch to the on position. or Pressing and holding the “Home” keypad button (the “Home” button is the middle keypad button located in the row of five buttons closest to the touchscreen) while sliding the power switch to the on position.
It’s Under Control® Chapter 3 | operation BACKLIGHT LEVEL (Ambient Light Sensor Enabled) If the light sensor is enabled, there are two backlight levels to adjust. Press the left arrow or right arrow buttons to adjust. Press the OK button when finished. With the light sensor enabled, the backlight brightness will automatically change between the two levels, depending upon the ambient lighting conditions.
T3-V+ Universal System Controller Chapter 3 | operation TILT SWITCH This button displays a window that allows you to adjust the settings for the built-in tilt sensor. The tilt switch is a motion detector that turns the remote on when activated. Press the OK button when finished. On means the tilt switch is active and will wake-up the T3-V+ when it is moved. Off means the tilt switch is inactive.
It’s Under Control® Chapter 3 | operation BATTERY This button displays a window that allows you to adjust the relative amount of time that the low battery icon appears on the display. This setting will determine how much time you have between the appearance of the low battery warning and the battery becoming completely depleted. The default warning time is Medium. Depending upon the age of the battery and daily usage habits, it may be beneficial to adjust this time. Press the OK button when finished.
T3-V+ Universal System Controller Chapter 3 | operation CALIBRATE TOUCHSCREEN This button runs a routine that allows you to calibrate the touchscreen. Since it normally should not be necessary to calibrate the touchscreen, this routine is included as a precaution only. Press the Calibrate button to continue. Follow the directions on the display to complete the calibration process. WARNING! DO NOT ATTEMPT TO CALIBRATE THE TOUCHSCREEN WITH YOUR FINGERTIP.
It’s Under Control® Chapter 3 | operation NETWORK INFORMATION This button displays a window that allows you to view the wireless networking information. This is for troubleshooting purposes only, all networking configuration must be made in Integration Designer®. Press the OK button when finished. The Mode field will show “Disabled” if it is disabled or “Not Connected” if it is enabled but does not have an active wireless connection. The Enable button does not take effect until the OK button is pressed.
T3-V+ 28 Universal System Controller
It’s Under Control® Chapter 4 | Power Power Management Infrared Control Range Infrared Frequency Transmission Range Specifications 3.6 VDC, 1700 mAh Lithium-Ion Battery Pack Automatic On/Off (tilt switch) 30 feet (9.1 meters) @ 60 degrees 15 kHz - 460 kHz Radio Frequency Control Range Up to 100 feet (30.5 meters) with optional System Interfaces/Processors Radio Frequency Carrier 802.15.4 @ 2.4 GHz (ZigBee® Wireless Mesh Networking) and 433MHz Wireless Ethernet 802.11g @ 2.
T3-V+ 30 Universal System Controller
It’s Under Control® Chapter 5 | Troubleshooting If you are having problems with your T3-V+ Universal System Controller, please read the information below before contacting technical support. If you continue to have problems, see Chapter 6 for more information on contacting RTI technical support. DISPLAY IS DIM, BLANK OR UNREADABLE Make sure the battery pack connector is attached properly and the battery is charged.
T3-V+ 32 Universal System Controller
It’s Under Control® Chapter 6 | Service and Support For news about the latest updates, new product information, and new accessories, please visit our web site at: www.rticorp.com CONTACTING RTI For general info, you can contact RTI at: Tel. (952) 253-3100 Fax (952) 253-3131 info@rticorp.com RTI TECHNICAL SUPPORT At RTI, customer service and satisfaction is an utmost priority.
T3-V+ Chapter 6 Universal System Controller | Service and Support Shipment of T3-V+ for Service RTI will pay all labor and material expenses for all repairs covered by this product’s warranty. If necessary repairs are not covered by warranty, or if a unit is examined which is not in need of repair, you may be charged for the repairs or examination. If it is necessary to ship the T3-V+ Universal System Controller for service: Please pack it securely (we suggest that it be insured).
It’s Under Control® Index Battery and Charging.................................................................... 14 Battery Warnings and Disposal......................................................... 5 Button Keycap Replacement............................................................ 19 Cleaning...................................................................................... 13 Contents....................................................................................... 9 Control Panel.......
T3-V+ Universal System Controller It’s Under Control® Remote Technologies Incorporated 5775 12th Avenue East, Suite 180 Shakopee, MN 55379 Tel: 952-253-3100 Fax: 952-253-3131 www.rticorp.com © 2010 Remote Technologies Inc. All rights reserved.