It’s Under Control ® T1 Operation Guide Professional Capture System Universal Infrared SystemCode Controller © 2004 Remote Technologies Inc. All rights reserved. Printed in Taiwan. IR-PRO T1 18681 Lake Drive East Chanhassen, MN 55317 Tel: 952-253-3100 Fax: 952-253-3131 www.rticorp.com IR-PRO Remote Technologies Incorporated Professional Infrared Code Capture System v1.
FEDERAL COMMUNICATIONS COMMISSION NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
T1 Universal System Controller BATTERY DISPOSAL Li-ion For environmental reasons, your T1 universal system controller uses “environmentally sound” Lithium-ion rechargeable batteries. These batteries do not contain any poisonous heavy metals that can damage the environment. In the interest of recycling, please do not dispose of these batteries in the household waste at the end of their useful life. Instead, dispose of them at an appropriate collection site. SAFETY SUGGESTIONS Read Instructions.
T1 Universal System Controller Macro Capability Total number of macros limited only by memory Servicing. Do not attempt any service beyond that described in the operating guide. Refer all other service needs to qualified service personnel. Macros allowed on every button Damage Requiring Service. The unit should be serviced by qualified service personnel when: Up to 64 steps per macro Communications USB programming port Dimensions Length: 9.3 in. (235mm) Width: 2.5 in. (64mm) Height: 1.1 in.
T1 Universal System Controller Remote Technologies Incorporated is not liable for any damages caused by its products or for its failure of its products to perform, including any lost profits, lost savings, incidental damages, or consequential damages. Specifications Power 3.6 VDC, 1050 mAH Li-Ion Battery Pack Power Management Automatic On/Off (tilt switch) Infrared Control Range 30 Feet (9.1m) @ 60 Degrees Infrared Frequency Range 15kHz – 460kHz Radio Frequency Control Range Up to 100 Feet (30.
T1 Universal System Controller If you are having a problem with hardware, please note the equipment in your system, a description of the problem, and any troubleshooting you have already tried. Contents Federal Communications Commission Notice ---------------------- i If you are having a problem with software, please note what version you have installed, the operating system on your PC, a description of the problem, and any troubleshooting you have already tried.
T1 Universal System Controller Chapter 4. Troubleshooting -------------------------------------------- 11 Chapter 5. Service and Support USB Communication Problems --------------------------------------- 11 IR Code Problems -------------------------------------------------------- 11 Chapter 5.
T1 Universal System Controller Chapter 1. Welcome Thank you for purchasing the T1 universal system controller. The T1 provides the perfect selection of buttons to operate today’s sophisticated home theaters. It is the ideal solution to enable easy control of any media system, no matter how complex, at an affordable price. The T1 features the same programming power and flexibility as RTI’s T2+ controller, but replaces the touchpanel display with 21 additional keypad buttons.
T1 Universal System Controller UNPACKING AND INSPECTION Chapter 4. Troubleshooting After unpacking your new T1 universal system controller, save all of the packing materials in case you ever have to ship the unit. Thoroughly inspect the T1 and packing materials for signs of damage. Report any damage to the carrier immediately. Report any equipment malfunctions to Remote Technologies Incorporated or an authorized Remote Technologies Incorporated distributor.
T1 Universal System Controller After the keycap is cut-out from one of the sets, simply press it over an empty keycap button. Make sure to press down firmly on the keycap until it is fully seated. Note: The keycaps can be permanently secured by using an adhesive that bonds to silicon rubber. The following instant adhesive glue works well and is readily available: Silicon Adhesive: Loctite PRISM® 401 (p/n 40104) U.S. Resellers: Contact East: # 173-606 McMaster-Carr: # 74765A63 Grainger: # 3KE58 Chapter 2.
T1 Universal System Controller ! A USB port for communication with the TheaterTouch Designer programming software. Chapter 3. Operation ! Non-volatile flash memory. The T1 will not lose any programmed data when the battery is removed. THE SOURCE BUTTONS ! One-year parts and labor warranty ! Available only to system integration professionals.
T1 Universal System Controller Introduction DOCKING STATION REFERENCE BATTERY AND DOCKING STATION Front Charge Contacts The T1 uses a Lithium-Ion rechargeable battery. This battery does not exhibit any type of “Memory Effect” from being charged too often. Since the T1 can safely be charged after each use, a docking station is included for convenience. If left out of the docking station, the T1 will remain in sleep mode for 1 – 2 months before shutting down. At that point the battery must be recharged.
Introduction T1 Universal System Controller The T1 is powered-up by touching any area of the display or any keypad button. If the tilt sensor is enabled, picking up the unit will also turn it on.
Introduction T1 Universal System Controller The T1 is powered-up by touching any area of the display or any keypad button. If the tilt sensor is enabled, picking up the unit will also turn it on.
T1 Universal System Controller Introduction DOCKING STATION REFERENCE BATTERY AND DOCKING STATION Front Charge Contacts The T1 uses a Lithium-Ion rechargeable battery. This battery does not exhibit any type of “Memory Effect” from being charged too often. Since the T1 can safely be charged after each use, a docking station is included for convenience. If left out of the docking station, the T1 will remain in sleep mode for 1 – 2 months before shutting down. At that point the battery must be recharged.
T1 Universal System Controller ! A USB port for communication with the TheaterTouch Designer programming software. Chapter 3. Operation ! Non-volatile flash memory. The T1 will not lose any programmed data when the battery is removed. THE SOURCE BUTTONS ! One-year parts and labor warranty ! Available only to system integration professionals.
T1 Universal System Controller After the keycap is cut-out from one of the sets, simply press it over an empty keycap button. Make sure to press down firmly on the keycap until it is fully seated. Note: The keycaps can be permanently secured by using an adhesive that bonds to silicon rubber. The following instant adhesive glue works well and is readily available: Silicon Adhesive: Loctite PRISM® 401 (p/n 40104) U.S. Resellers: Contact East: # 173-606 McMaster-Carr: # 74765A63 Grainger: # 3KE58 Chapter 2.
T1 Universal System Controller UNPACKING AND INSPECTION Chapter 4. Troubleshooting After unpacking your new T1 universal system controller, save all of the packing materials in case you ever have to ship the unit. Thoroughly inspect the T1 and packing materials for signs of damage. Report any damage to the carrier immediately. Report any equipment malfunctions to Remote Technologies Incorporated or an authorized Remote Technologies Incorporated distributor.
T1 Universal System Controller Chapter 1. Welcome Thank you for purchasing the T1 universal system controller. The T1 provides the perfect selection of buttons to operate today’s sophisticated home theaters. It is the ideal solution to enable easy control of any media system, no matter how complex, at an affordable price. The T1 features the same programming power and flexibility as RTI’s T2+ controller, but replaces the touchpanel display with 21 additional keypad buttons.
T1 Universal System Controller Chapter 4. Troubleshooting -------------------------------------------- 11 Chapter 5. Service and Support USB Communication Problems --------------------------------------- 11 IR Code Problems -------------------------------------------------------- 11 Chapter 5.
T1 Universal System Controller If you are having a problem with hardware, please note the equipment in your system, a description of the problem, and any troubleshooting you have already tried. Contents Federal Communications Commission Notice ---------------------- i If you are having a problem with software, please note what version you have installed, the operating system on your PC, a description of the problem, and any troubleshooting you have already tried.
T1 Universal System Controller Remote Technologies Incorporated is not liable for any damages caused by its products or for its failure of its products to perform, including any lost profits, lost savings, incidental damages, or consequential damages. Specifications Power 3.6 VDC, 1050 mAH Li-Ion Battery Pack Power Management Automatic On/Off (tilt switch) Infrared Control Range 30 Feet (9.1m) @ 60 Degrees Infrared Frequency Range 15kHz – 460kHz Radio Frequency Control Range Up to 100 Feet (30.
T1 Universal System Controller Macro Capability Total number of macros limited only by memory Servicing. Do not attempt any service beyond that described in the operating guide. Refer all other service needs to qualified service personnel. Macros allowed on every button Damage Requiring Service. The unit should be serviced by qualified service personnel when: Up to 64 steps per macro Communications USB programming port Dimensions Length: 9.3 in. (235mm) Width: 2.5 in. (64mm) Height: 1.1 in.
It’s Under Control ® T1 Operation Guide Professional Capture System Universal Infrared SystemCode Controller © 2004 Remote Technologies Inc. All rights reserved. Printed in Taiwan. IR-PRO T1 18681 Lake Drive East Chanhassen, MN 55317 Tel: 952-253-3100 Fax: 952-253-3131 www.rticorp.com IR-PRO Remote Technologies Incorporated Professional Infrared Code Capture System v1.