User Manual

The OUV 200/601/702 module is a wireless outdoor camera

activated by a connected detector. It is designed for use in

Videofied

security systems.

• Polyvalent 90° infrared camera

• 4 infrared LEDs for extended night vision

• Protection marking IP54

• Température resistant (-25°C/+70°C)

• Transmits check-in/status signal every 8 minutes

• 8-pin control connector

Product Description

Installation Guidelines

For easier installation, programming and RF testing should be done to check for good communication between the control panel

and all system devices before mounting system devices.

Install the detector and other system devices in the order of the following steps:

> Programming/RF Testing - program detector and all other devices into the control panel and test RF communication from each

intended device location to the control panel.

> Mounting - mount detector at the tested location.

Mounting instructions

> The module is mounted through 2 backside screw threads (2mm x 7,5 mm).

> Plug the connector to the detector (the use of a short cable is permissible).

> Mount the detector according to the manufacturer recommendations.

DOC. - REF. 213-OUV

VERSION : JUNE 2016

INSTALL SHEET

OUV OUTDOOR UNIVERSAL VIEWER

PAGE 1
OUV OUTDOOR UNIVERSAL VIEWER INSTALL SHEET DOC. - REF. 213-OUV VERSION : JUNE 2016 Product Description The OUV 200/601/702 module is a wireless outdoor camera activated by a connected detector. It is designed for use in Videofied ® security systems.
PAGE 2
OUV OUTDOOR UNIVERSAL VIEWER INSTALL SHEET Programming/RF Testing/Mounting The following provides summarized steps for device programming, testing, and mounting. For complete details, refer to the control panel installation manual. 1 Put control panel into Programming/Configuration mode. 2 Using a programmed alphanumeric keypad, proceed through menus until the display shows ADD A NEW DEVICE. 3 Press OK/YES. the display shows PRESS PROGRAM BUTTON OF DEVICE.
PAGE 3
INSTALL SHEET OUV OUTDOOR UNIVERSAL VIEWER FCC Regulatory Information for USA and CANADA FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC authorization to operate this equipment. FCC Part 15.105 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 4
OUV OUTDOOR UNIVERSAL VIEWER INSTALL SHEET ELECTRICAL PROPERTIES Panel compatibility VIDEO PROPERTIES W, XL, XT, XV and their variants 8-pin connector Power 2.