Installation Instructions

ManualsBrandsRSI VIDEOTECHNOLOGIES ManualsElectronicsIndoor Siren

www.videofied.com

Product Summary

The Interior Siren SE601 is a wireless siren

designed for use with Videoﬁed security systems.

The siren includes the following features:

Totally wireless, battery operated.

Dual tamper function provides detection for both wall

and cover tamper.

Transmits check-in/status signal every 8 minutes.

Installation Guidelines

For easier installation, programming and RF testing

should be done to check for good communication between

the control panel and all system devices before mounting

system devices. Install the siren and other system devices

in the order of the following steps:

Programming/RF Testing - program siren and

all other devices into the control panel and test

RF communication from each intended device

location to the control panel.

Mounting - mount siren at the tested location.

Programming/RF Testing

The following provides summarized steps for device

programming and testing. For complete details, refer

to the control panel installation manual.

Remove bottom screws,

separate cover from siren

and install batteries.

Put control panel

into programming/

conﬁguration mode.

Using a programmed

alphanumeric keypad,

proceed through menus

until the display shows

ADD A NEW DEVICE.

Press Yes. The display

shows PRESS PROGRAM

BUTTON OF DEVICE.

Press and release

program button on siren

using a paper clip end.

The siren LED ﬂashes.

Wait for keypad display

to show SIREN (1 - 25)

RECORDED.

Press Yes. The display shows RADIO RANGE TEST?

Press Yes again. The siren LED starts ﬂashing and

keypad display shows TEST IN PROGRESS.

Take siren to its intended mounting location and

make sure LED ﬂashes continuously, indicating good

communication with control panel.

Press Yes to end radio range test, then press Esc/No.

The display shows RECORDING A NEW DEVICE?

Repeat steps 4 - 8 for remaining sirens.

When ﬁnished, exit from conﬁguration mode.

Screws

Program Button

PRODUCT INSTALLATION SHEET

Indoor Siren SE601

Made by RSI VIDEO TECHNOLOGIES 2205 - SEIS March 2012

Summary of content (3 pages)

PAGE 1
Indoor Siren SE601 P R O D U C T I N S TA L L ATI O N S H E E T Made by RSI VIDEO TECHNOLOGIES 2205 - SEIS March 2012 Product Summary Installation Guidelines The Interior Siren SE601 is a wireless siren designed for use with Videofied security systems. The siren includes the following features: For easier installation, programming and RF testing should be done to check for good communication between the control panel and all system devices before mounting system devices.
PAGE 2
Indoor Siren SE601 I N S TA L L ATI O N DATA S H E E T Mounting > Use proper tools and hardware. 1 Remove batteries. > Mount where siren can be heard by occupants. 2 Hold unit up against mounting surface and mark the three mounting holes. 3 Drill pilot holes and install anchors Mounting Holes where needed. 4 Place unit on mounting surface so mounting holes line up with pilot holes/anchors and secure unit with appropriate screws. 5 Install batteries, observing correct polarity.
PAGE 3
Indoor Siren SE601 P R O D U C T I N S TA L L ATI O N S H E E T FCC Regulatory Information for USA and CANADA FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI VideoTechnologies may void the FCC authorization to operate this equipment. FCC Part 15.105 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.