User's Manual

ManualsBrandsRSI VIDEOTECHNOLOGIES ManualsElectronicsOutdoor Siren

Doc. - Ref. 216-OSX

Version : March 2014

The OSX Outdoor Siren is designed for use with a

Videofied™ wireless alarm system.

Its main features are :

• Completely wireless and powered with

alcaline batteries : 4 years battery life.

• Dual tamper function provides detection for

both wall and cover tamper.

• Transmits check-in/status signals every 8

minutes

• Flash LED light

• 100 dBA output level at 1 m

• 3 to 15 minutes output and flashlights

duration (according to local legislation).

Product Presentation

Installation guidelines

For easier installation, programming and RF testing should

be done to check for good communication between the

control panel and all system devices before mounting system

devices. Install the siren and other system devices in the order

of the following steps :

Mounting - mount siren at the tested location.

Programming/RF Testing - program the siren and all other

devices into the control panel and test RF communication

from each intended device location to the control panel.

Mounting

Use proper tools and hardware for mounting the unit.

Mount outdoors under eves to help prevent direct

contact from elements.

Mount on front of structure where strobe light is clearly

visible to responding authorities.

Press both side buttons together to open the siren box.

Hold up the siren base against the mounting surface and

mark the four mounting holes.

Drill pilot holes and install anchors where needed.

Place unit on mouning surface so mounting holes line up

with pilot holes/anchors and secure unit with appropriate

screws.

Install 3 LR 1.5V batteries, observing correct polarity.

Attach front cover and lock with the screws.

Mounting holes

PRODUCT INSTALL SHEET

OSX Outdoor Siren

www.videoﬁed.com

Summary of content (5 pages)

PAGE 1
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T Doc. - Ref. 216-OSX Version : March 2014 Product Presentation The OSX Outdoor Siren is designed for use with a Videofied™ wireless alarm system. Its main features are : • • • • • • Completely wireless and powered with alcaline batteries : 4 years battery life. Dual tamper function provides detection for both wall and cover tamper.
PAGE 2
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T Programming/RF Testing The following provides summarized steps for device programming and testing. For complete details, refer to the control panel installation manual. 1 With the programming keypad, browse to the ADD A NEW DEVICE menu (Level 4). 2 Press OK/YES. The keypad displays PRESS PROGRAM BUTTON OF DEVICE. 3 Press and release program button on siren using a paper clip end. The siren LED flashes.
PAGE 3
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T Use only the flashlights or only the output Enable delay beeps By default, the output and the flashlights are enabled when the OSX is active. You can enable one or the other. By default, delay beeps are disabled on the OSX outdoor siren. You can enable those delay beeps. Lvl. 4 Lvl.
PAGE 4
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit English • • • • Remove battery before any maintenance ! WARNING, there is a risk of explosion if a battery is replaced by an incorrect type! Observe polarity when setting up the batteries! Do not throw used batteries! Bring them to your installer or a collection point.
PAGE 5
OSX Outdoor Siren P R O D U C T Electrical Data I N S T A L L S H E E T Physical Data Panel Compatibility Power requirements XL, XLL XT, XV, VISIO 4.5V DC with 3 LR20, 1.