User Manual

KF 240/641/742 4-BUTTONS REMOTE KEYFOB
INSTALLATION SHEET
DOC. - REF. 217-KF
EDITION DATE : FEBRUARY 2016
1
Operation
Press briefly and release the corresponding button to arm
(full arming or partial arming) or disarm.
The first beep confirms the button has been pressed. Two beeps
confirm that the panel has received the command. If the panel has
not received the command, only one beep is emitted by the keyfob.
A red double flash confirm the system full or partial arming. A green
double flash confirms disarming.
To trigger an alert, press and hold one of the partial arming keys for
2 seconds.
> Note : This keyfob is powered by a CR3032 lithium battery with a
5-year battery life.
Commands
Full
Arming
Partial
arming 1
Siren alert after
holding for 2 seconds
Disarming
Partial
arming 2
Silent alert after
holding for 2 seconds
Visual arming status
after holding for 2
seconds
Press and hold ___ & __
simultaneously for 5 seconds
The keyfob emits delay beeps when the system is armed. You can
determine if a door contact is still open.
If a device is detecting while the panel is arming, the keyfob emits a
4-second long beep.
You do not need to wait for the beeps to stop to leave the premises. The
beeps will automatically stop after the configured exit delay.
Visual arming status
System
disarmed
System
armed
Programming
Enable the device recording mode on the panel, the keypad
will display “PRESS PROGRAM BUTTON OF DEVICE”.
Press and hold the keyfob & keys simultaneously.
When releasing, the keyfob emits a beep and a flash every
second then the keyfob is recorded by the panel.
If the keyfob is not recorded, confirm that the keypad is
displaying:
then press and hold the keyfob & keys again (by
strongly pressing the buttons).
PRESS PROGRAM
BUTTON OF DEVICE