User's Manual

ManualsBrandsRSI VIDEOTECHNOLOGIES ManualsElectronicsDoor/Window contact

Doc. - Ref. 219-IDC

Version : April 2014

Installation Guidelines

For easier installation, programming and RF testing should be done

to check for good communication between the control panel and all

system devices before mounting system devices. Install the detector

and other system devices in the following order:

Programming/RF Testing - program detector and all other devices

into the control panel and test RFcommunication from each intended

device location to the control panel.

Mounting - Mount detector at the tested location.

Mounting Rules

> Use proper tools and hardware.

> Mount indoors in a temperature controlled environment.

> Mount detector on frame and magnet assembly on movable

opening (door, window).

> Do not exceed 20 mm (6/8”) gap between detector and magnet.

> Magnet spacer must be used to match magnet height with detector

to ensure correct alignment and functionality.

> Do not install product on ferromagnetic surfaces.

The Indoor Door Contact IDC 200/601/701 is a wireless

door/window contact designed for use with Videoﬁed

security systems. The contact includes the following

features:

> Uses 1 Duracell CR123A Lithium battery for long life.

> Dual tamper function provides detection for both wall

and cover tamper.

> Transmits check-in/status signal every 8 minutes.

Product Summary

Door

Mounting

Holes

Wall

Mounting

Holes

Magnet Base

PRODUCT INSTALLATION SHEET

Indoor Door Contact

IDC200/601/702 (white) / IDC 210 (brown)

www.videoﬁed.com

Summary of content (4 pages)

PAGE 1
Indoor Door Contact IDC200/601/702 (white) / IDC 210 (brown) P R O D U C T I N S T A L L A T I O N S H E E T Doc. - Ref. 219-IDC Version : April 2014 Product Summary The Indoor Door Contact IDC 200/601/701 is a wireless door/window contact designed for use with Videofied security systems. The contact includes the following features: > Uses 1 Duracell CR123A Lithium battery for long life. > Dual tamper function provides detection for both wall and cover tamper.
PAGE 2
Indoor Door Contact IDC200/601/702 (white) / IDC 210 (brown) P R O D U C T I N S T A L L A T I O N S H E E T Programming/RF Testing/Mounting The following provides summarized steps for device programming, testing and mounting. For complete details, refer to the control panel installation manual. 1 Loosen bottom screw and separate base from detector. 7 Press YES/OK. The display shows RADIO RANGE TEST? Press YES/OK again. The detector LED starts flashing and keypad display shows TEST IN PROGRESS.
PAGE 3
Indoor Door Contact IDC200/601/702 (white) / IDC 210 (brown) P R O D U C T I N S T A L L A T I O N S H E E T (EN) Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit English Francais Deutsch > Remove batteries before any maintenance! > WARNING, there is a risk of explosion if a battery is replaced by an incorrect type! > Attention ! Il y a un risque d’explosion si l’une des piles utilisées est remplacée par une pile de type incorrect ! > Batterien vor jeglichen Wartungsarbeiten en
PAGE 4
P R O D U C T Properties Physical Data Panel Compatibility XL, XLL, Visio, XT, XV and their variants Power Requirements Nominal Voltage 3.0V Low battery limit 2.