Assembly Instructions

ManualsBrandsRound 2 ManualsElectronics2 Lane Terminal For 4 Lane

• This race set is not intended for children under 3 years

of age.

• If this race set is being operated in the presence of

children under 8 years old, adult supervision is advised.

• Select a hard, ﬂat and clean surface to assemble your

track layout.

• Select a location close to a convenient power

receptacle and ensure the adjustable voltage power pack

cable is not stretched too tight. This may cause it to

malfunction or create a tripping hazard.

• Assemble track layout before connecting speed

controllers or adjustable voltage power pack.

• Plug in speed controllers before connecting adjustable

voltage power pack to terminal track. Plug adjustable

voltage power pack into wall receptacle LAST.

• Only use included AUTO WORLD adjustable voltage

power pack with this race set.

• Unplug adjustable voltage power pack when

assembling, disassembling or CLEANING Track.

• Always unplug adjustable voltage power pack when

race set is not in use.

• When connecting or disconnecting the speed

controllers or adjustable voltage power pack, always grip

the connector and NOT the cable.

• Inspect adjustable voltage power pack cable,

connector and transformer for damage BEFORE EACH

USE, and regularly thereafter. Check for the following

problems:

- exposed or frayed cable wires

- nicks or cuts in cable insulation

If any damage is discovered, DO NOT use the adjustable

voltage power pack or race set until the problem has

been corrected.

• The adjustable voltage power pack is NOT a toy.

• DO NOT attempt to open or modify the adjustable

voltage power pack - No consumer

serviceable parts inside.

• Disconnect the adjustable voltage power pack before

cleaning it.

WARNING

- This race set contains parts with sharp edges. Unpacking,

assembly and use should take place only under direct supervision of an adult.

ELECTRIC SLOT CAR

RACE SET

After unpacking your race set, use the list below to ensure all the parts are present.

If something appears to be missing, check again through all the packing materials and

carton to make sure no parts were missed when unpacking.

[4] x XTRACTION

RACERS

[25] x GUARD RAIL

[1] x ADJUSTABLE VOLTAGE POWER PACK

[1] x 4 in 1 CHARGING CABLE

[4] x WIRELESS SPEED CONTROLLERS

[1] x TRACK CLEANING PAD

SRS345

[4] x 9" STRAIGHT TRACK

[2] x 5" STRAIGHT TRACK

[6] x 6" STRAIGHT TRACK

[20] x 15" STRAIGHT TRACK

[5] x 9" CURVE TRACK 1/8 CIRCLE

[8] x 9" CURVE TRACK 1/4 CIRCLE

[1] x 15" 4-LANE WIRELESS TERMINAL & CONNECTION TRACK

[2] x 9" LAP COUNTER TRACK

[11] x 6" CURVE TRACK 1/8 CIRCLE

[13] x 12" CURVE TRACK 1/8 CIRCLE

[8] x 6" CURVE TRACK 1/4 CIRCLE

[11] x 15" CURVE TRACK 1/8 CIRCLE

CONNECTOR

CABLE

ADJUSTABLE

DIAL

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two

conditions:

1) this device may not cause harmful interference,

and

2) this device must accept any interference received,

including interference that may cause undesired

operation.

Changes or modiﬁcations not expressly approved by

the party responsible for compliance could void your

authority to operate the equipment.

NOTE: This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV

technician for help.

FCC STATEMENT

Summary of content (2 pages)

PAGE 1
ELECTRIC SLOT CAR RACE SET • This race set is not intended for children under 3 years of age. • If this race set is being operated in the presence of children under 8 years old, adult supervision is advised. • Inspect adjustable voltage power pack cable, connector and transformer for damage BEFORE EACH USE, and regularly thereafter.
PAGE 2
This race set track layout requires an area of 102" x 50". PLEASE READ “SAFE SET-UP REMINDERS” ON BACK OF THIS MAP BEFORE ASSEMBLING RACE SET! Extra guard rails are included in the set as replacements. They may also be added to other track pieces as desired. Following this map, loosely lay out all track pieces first before making connections. Attach guard rails to all curved track (outside) sections before assembly. Pairing the Wireless Controllers to the Terminal Track: 1.