MATERIAL SAFETY DATA SHEET 1. Identification of the substance or mixture and of the supplier GHS product identifier : HANWHA LLDPE 9730 Recommended use of the chemical and restrictions on use. Recommended use: Industrial resin. Restrictions on use: Used for recommended use. Supplier identifier.
3. Composition/information on ingredients Chemical Name Common Name Synonyms CAS number Content (%) LINEAR LOW-DENSITY POLYETHYLENE LLDPE 9002-88-4 >99.8 Additives - - <0.5 4. First aid measures Eye contact: If you occur symptoms, keep away from exposure. Flush eyes with running water for more than 15 minutes. Call a POISON CENTER or doctor/physician if you need. Skin contact: Take off contaminated clothing and shoes, wash with soap and water for at least 15 minutes.
5. Firefighting measures Suitable (and unsuitable) extinguishing media Suitable extinguishing media: Dry chemical, CO2, water, regular foam. unsuitable extinguishing media: Do not use straight streams. In case of major fire and large quantities: Use dry chemical or water spray. Specific hazards arising from the chemical Thermal decomposition products: Flammable and toxic gas, carbon oxides. It could be a slight fire hazard.
Precautions for safe handling: Avoid heat, sparks, flames and other sources of ignition. Do not eat, drink or smoke in product area. In pneumatic conveying and machine operation, take care the occurrence of dust. To reduce the potential for dust explosion suppression, the ground connection caused static electricity. Try not to be the accumulation of dust. Conditions for safe storage: Store in a closed container. Avoid heat, sparks, flames, strong acid.
. Physical and chemical properties Appearance: Solid (Pellet, White) Odor: odorless Odor threshold: Not available Tatse: Not available Taste threshold: Not available pH: Not available Melting point/freezing point: 110 ~ 130°C Initial boiling point and boiling range: Not available Flash point: >231°C Evaporation rate: Not available Flammability: Not available Upper/lower flammability or explosive limits: Not available Vapor pressure: Small enough to neglected at 25°C Vapor density: Not applicable Relative d
Possibility of hazardous reactions: No dangerous reaction under conditions of normal use. Conditions to avoid (e.g., static discharge, shock or vibration): May decompose over 350℃ (662℉). Incompatible materials: Nitrate, chlorate, peroxides, strong acid. Hazardous decomposition products: Methane, Propane, Carbon oxide, Aldehyde, Organic Vapor. 11.
-IARC: 3 -ACGIH, NTP, OSHA, EC Directive 1272/2008, US EPA: not listed -Using a mouse or a rat carcinogenicity studies found in the ovarian cancer and uterine sarcoma, but its population is just less carcinogenic in classification is not enough data. Mutagenicity: Not classified -In vitro - Ames reversion test(S.
shall be incinerated. 2) Matters which require attention when disposing waste: • Standard and method for disposing the designated waste -All the generated waste shall be disposed in accordance with the specific standard and method prescribed in the Act so that the environmental pollution may be minimized in the course of collecting, carrying, keep and disposing the waste. -The waste shall not flutter or flow out, and a bad smell shall not be diffused.
EPCRA 313: Not regulated TSCA Section 8(b) Inventory : XU FDA - Direct Food Additives: 21 CFR 172.
The information contained herein is to the best of our knowledge and belief accurate. However, since the conditions of handling and use are beyond our control, we make no guarantee for result obtained, and assume no responsibility for damages incurred by use of this product. It is the responsibility of the user to comply with all federal, state and local laws and regulations.