Networing RC-415/RC-416 USER’S Manual
Networing RC-415/416 USER’S Manual FCC Certifications This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Networing RC-415/416 USER’S Manual Introduction The device is a powerful, high-performance Gigabit Ethernet switch, with all ports capable of 10, 100 or 1000Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications.
Networing RC-415/416 USER’S Manual LED Definition Please refer to the following table for LED definition: 1 2 3 4 5 POWER LINK/ACT RC-415 5-port Gigabit Switch 1 2 3 4 5 6 7 8 POWER LINK/ACT RC-416 8-port Gigabit Switch LED Power Link/ACT Status Operation Steady Green Power is on Off Power is off Steady Green Port connected Blinking Green The port is transmitting/receiving data 3
Networing RC-415/416 USER’S Manual Stations Connection Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. Switches Connection In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable.
Networing RC-415/416 USER’S Manual IEEE 802.3 10BASE-T Standard IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control IEEE 802.3az Draft Energy Efficient Ethernet RC-415 - 5* 10/100/1000Mbps RJ-45 Gigabit Interface Ethernet ports RC-416 - 8* 10/100/1000Mbps RJ-45 Gigabit Ethernet ports Uplink Network Speed Auto MDI/MDI-X(Auto crossover) 10/100/1000Mbps & Full/Half duplex mode auto detection (1000Mbps for Full duplex only) MAC Addr.