Dual Multimedia Headrest Replacement Entertainment System Quick Start Guide
NOTICES NOTICE OF INTENDED USE Rosen Electronics are designed to enable viewing of video ONLY for rear-seat occupants, and are not intended for viewing by the driver when the vehicle is in motion. Such use might distract the driver or interfere with the driver’s safe operation of the vehicle, and thus result in serious injury or death. Such use might also violate state or local laws.
For complete Owner’s Manual, please visit Rosen Electronics online at www.RosenElectronics.
Turning On The System A) Turn vehicle ignition to ON or ACC B) Press POWER on the front display or wireless remote on each system Front Panel Controls POWER/ENTER HOME/BACK SPEAKER DOWN UP RIGHT/NEXT LEFT/PREVIOUS 1 EJECT PLAY/PAUSE
Using The Headphones A) Turn on by pressing the OFF/ON button located on the ear piece. The power LED on the ear piece should illuminate. If not, check that the batteries are inserted properly and have a charge. B) The headphones each have a two-position slide switch labeled “Ch.A/ Ch.B”. They must have a clear line of sight to the headrest monitor and must be switched to the designated A/B Channel to operate properly. C) To adjust the volume, use the knob on the ear piece.
Playing A Disc A) Use the LEFT or RIGHT button to navigate to DVD mode. B) Press the ENTER button to select DVD source. C) With the label facing away, insert a disc into the disc slot. Do not force disc into slot. If a DVD/CD menu appears on the screen, press PLAY or ENTER as instructed on the screen. Most disc will load and play automatically. D) To obtain best viewing angle, adjust the screen display as needed by pressing the bottom corners of the screen housing.
Digital Media Player The USB/MicroSD sources can be used for media playback, such as video, audio and photos. Use the LEFT or RIGHT arrows to the next page. Use the UP or DOWN arrows to navigate the folder. RETURN to go back previous screen. Use The HOME to return to the main menu. External Sources HDMI: The system supports up to 2 external HDMI devices, such as Smart Phone,Tablet, Gaming Console or any device with HDMI output. AUX: A composite 3.
Adjusting The Display From the Home page, navigate to Settings and press Enter. Press the UP arrow button to brighten the screen or press the DOWN arrow button to dim the screen. Once you are done, press the BACK or HOME button to exit the SETTINGS. Auto On Displays The system can be set to turn on automatically whenever the ACC is on. To set the system to turn on automatically, within the SETTINGS menu press the LEFT arrow button to select Auto On Display.
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: following two 1) this device may not cause harmful interference, and conditions: 2) this device must accept any interference received, including interference cause 1)that this may device mayundesired not causeoperation.
PN: QSG1002 Rev A Copyright © 2015 Rosen Electronics, All rights reserved.