Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM™ Adapter
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Smart Wireless THUM™ Adapter Smart Wireless THUM Adapter Hardware Revision HART® Device Revision Field Communicator Field Device Revision 1 1 Dev v2.5 DD v4 NOTICE Read this manual before working with the product. For personal and system safety, and for optimum product performance, make sure to thoroughly understand the contents before installing, using, or maintaining this product.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter NOTICE Explosions could result in death or serious injury: Installation of this transmitter in an explosive environment must be in accordance with the appropriate local, national, and international standards, codes, and practices. Please review the approvals section of the THUM reference manual for any restrictions associated with a safe installation.
Reference Manual 00809-0100-0775, Rev AA March 2009 Section 1 Smart Wireless THUM Adapter Overview Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-2 Considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-3 Return of Materials . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Overview Manual Transmitter This manual is designed to assist in the installation, operation, and maintenance of Smart Wireless THUM Adapter.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Considerations General The Smart Wireless THUM Adapter is connected to a HART sub-device. With simple HART configuration, the THUM transmits the HART information from the sub-device unto the WirelessHART network. Commissioning The THUM can be commissioned before or after installation.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Environmental Verify that the operating atmosphere of the transmitter is consistent with the appropriate hazardous locations certifications. Temperature Effects The transmitter will operate within specifications for ambient temperatures between –40 and 185 °F (–40 and 85 °C).
Reference Manual 00809-0100-0775, Rev AA March 2009 Section 2 Smart Wireless THUM Adapter Configuration Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-1 Device Sensor Configuration . . . . . . . . . . . . . . . ... . . . . . . page 2-2 Device Network Configuration . . . . . . . . . . . . . .. . . . . . . .
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Connections The THUM is compatible with a number of sub-devices. See section 3 for details on wiring the THUM to different types of sub-devices. THUM Configuration The THUM will receive any HART communication from a handheld Field Communicator, or AMS®. In order for the THUM to receive HART communication the sub-device must be powered.
Reference Manual 00809-0100-0775, Rev AA March 2009 Section 3 Smart Wireless THUM Adapter Mounting Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1 Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-2 Direct Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-2 Remote Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-4 Ground the Transmitter . . . . . . .
Reference Manual 00809-0100-0775, Rev AA March 2009 Mounting Direct Mount Smart Wireless THUM Adapter The THUM can be installed in one of two configurations: Direct Mount, where the THUM is connected directly to the conduit entry of the sub-device, or Remote Mount, where the THUM is mounted separate from the sub-device housing, then connected to the sub-device via conduit. Choose the installation sequence that corresponds to the mounting configuration. 1.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 1. 2 Wire Sub-Device Plus THUM Wiring Diagram NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 2.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 2. 2 Wire Sub-Device Plus THUM Wiring Diagram with 250 Ohm Resistor NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 2.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 3. 4-Wire Sub-Device with Passive 4–20 mA LOOP Plus THUM Wiring Diagram NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 4.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 4. 4-Wire Sub-Device with Passive 4–20 mA LOOP Plus THUM Wiring Diagram with 250 Ohm resistor NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 4.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 5. 4-Wire Sub-Device with Active 4–20 mA LOOP Plus THUM Wiring Diagram NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 6.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 6. 4-Wire Sub-Device with Active 4–20 mA LOOP Plus THUM Wiring Diagram with 250 Ohm resistance NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 6.
Reference Manual 00809-0100-0775, Rev AA March 2009 Wiring Smart Wireless THUM Adapter Figure 7. 4-Wire Sub-Device with no 4–20 mA LOOP Plus THUM Wiring Diagram NOTE: In order for the THUM to function properly there must be 250 Ohms resistance in the loop. If the 4–20 mA loop does not have 250 Ohms resistance, wire a 250 Ohm resistor as shown in Figure 7.
Reference Manual 00809-0100-0775, Rev AA March 2009 Section 4 Smart Wireless THUM Adapter Commissioning Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1 Verify Operations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-2 SAFETY MESSAGES Warnings Instructions and procedures in this section may require special precautions to ensure the safety of the personnel performing the operations.
Reference Manual 00809-0100-0775, Rev AA March 2009 Verify Operations Smart Wireless THUM Adapter Operation can be verified in two locations, using the 375 Field Communicator, or at the Gateway via the Wireless Gateway’s integrated web server. 375 Field Communicator To verify device operation using a HART Field Communicator, a 648 DD is required. Smart Wireless Gateway To verify device operation using the 1420 Wireless Gateway’s integrated web server, navigate to the Explorer>Status page.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter This page will display the transmitter’s tag, PV, SV, TV, QV, Last Update, Update Rate, Battery Voltage, and Status. A green status indicator means that the device is working properly. A red indicator means that there is a problem with either the device or its communication path. For more detail on a specific device, click on the tag name.
Reference Manual 00809-0100-0775, Rev AA March 2009 Section 5 Smart Wireless THUM Adapter Operations and Maintenance Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-1 LCD Screen Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-2 SAFETY MESSAGES Warnings Instructions and procedures in this section may require special precautions to ensure the safety of the personnel performing the operations.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter Startup Sequence Due to the power scavenging of the THUM different capabilities will be available at different times after startup. Immediately after startup configuration of the THUM is available. This includes all network settings including Network ID and Join Key, and Update Rate. The THUM will not start to join the network until the radio turns completely on.
Reference Manual 00809-0100-0775, Rev AA March 2009 Appendix A Smart Wireless THUM Adapter Specifications and Reference Data Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page A-1 Dimensional Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . page A-3 Ordering Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page A-4 Specifications Functional Specifications Input Any 2- or 4-wire HART 5.0 powered device. Output WirelessHART.
Reference Manual 00809-0100-0775, Rev AA March 2009 Performance Specifications Smart Wireless THUM Adapter ElectroMagnetic Compatibility (EMC) All Models: Meets all relevant requirements of EN61326-1 (2006) . Vibration Effect Output unaffected when tested per the requirements of IEC60770-1 field or pipeline with high vibration level (10-60 Hz 0.21mm displacement peak amplitude / 60-2000 Hz 3g).
Reference Manual 00809-0100-0775, Rev AA March 2009 DIMENSIONAL DRAWINGS Smart Wireless THUM Adapter
Reference Manual 00809-0100-0775, Rev AA March 2009 Ordering Information Smart Wireless THUM Adapter
Reference Manual 00809-0100-0775, Rev AA March 2009 Appendix B Smart Wireless THUM Adapter Product Certifications Approved Manufacturing Locations . . . . . . . . . . . . . . . . . page B-1 Telecommunication Compliance . . . . . . . . . . . . . . . . . . . . page B-1 European Union Directive Information . . . . . . . . . . . . . . . page B-1 Ordinary Location Certification for FM . . . . . . . . . . . . . . . page B-2 Hazardous Locations Certificates . . . . . . . . . . . . . . . . . . .
Reference Manual 00809-0100-0775, Rev AA March 2009 Hazardous Locations Certificates Smart Wireless THUM Adapter North American Certifications Factory Mutual (FM) Approvals I5 FM Intrinsic Safety and Non-incendive Intrinsically Safe for Class I/II/III, Division 1, Groups A, B, C, D,E, F, and G. Zone Marking: Class I, Zone 0, AEx ia llC Temperature Codes T4 (Tamb = -50 to 70° C) Non-incendive for Class I, Division 2, Groups A, B, C, and D.
Reference Manual 00809-0100-0775, Rev AA March 2009 Hazardous Locations Certificates Smart Wireless THUM Adapter IECEx Certifications I7 IECEx Intrinsic Safety Certificate No.: See Certificate Ex ia IIC T5 (Tamb = -50 °C to 40 °C) Ex ia IIC T4 (Tamb = -50 °C to 70 °C) IP66 Special Conditions of Safe Use (X) The antenna does not meet the surface resistivity requirements and, to avoid electrostatic charging, it must only be cleaned with a damp cloth.
Reference Manual 00809-0100-0775, Rev AA March 2009 Smart Wireless THUM Adapter
