Installation & Assembly

assembly instructions

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. Prior to installing glass, ﬁxture can now be lamped accordingly. Note: During the

installation of the bulbs, do not touch the glass portion with your ﬁngers. Gloves are

recommended.

2. Clip glass bulb shields (2) onto socket (1) - see Drawing 2.

3. Attach bottom glass shield (3) using square screw (4).

4. Attach glass (5) using square screws (6).

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting the retainer plate to the junction box, making all necessary electrical

connections, mounting the backplate to the retainer plate and then installing the

ﬁxture glass.

start here

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

Drawing 1 - Fixture Mounting

Drawing 2 - Glass Installation

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1. To mount ﬁxture, slip the two mounting screws (B) through the two mounting holes

(D) in the backplate (E) - see Drawing 1.

2. While holding ﬁxture in place, thread the two ball knobs (F) on to the end

of the mounting screws (B), and tighten.

1. Release mounting strap (A) by removing the 2 ball knobs on the front of the ﬁxture’s

backplate (E) - see Drawing 1.

2. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)

into the back of the universal strap.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)

in the back plate (E).

3. Attach mounting strap (A) to junction box (J) using two 1” screws (C).

PAGE 1
assembly instructions start here Drawing 1 - Fixture Mounting A J C 1. Find a clear area in which you can work. D 2. Unpack fixture and glass from carton. B 3. Carefully review instructions prior to assembly. F *** The construction of this fixture will be accomplished by first mounting the mounting the retainer plate to the junction box, making all necessary electrical connections, mounting the backplate to the retainer plate and then installing the fixture glass. E 1.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount supply wire A C Indoor Fixtures E 1 2 twist-on connectors D B fixture leads Drawing 2 - Chain Hung supply wire A C E twist-on connectors 1 B D E wiring instructions 2 fixture leads 1.