DR101 / DR102 NFC DRIVER ID READER/WRITER USER MANUAL
Rosco Vision Systems® DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION TABLE OF CONTENTS DR101 NFC Driver ID Reader/Writer with RS232 Connection . . . . . . . . . . . . . . DR102 NFC Driver ID Reader/Writer with USB Connection . . . . . . . . . . . . . . . . . Device Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation on Computer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Device Specifications . . . . . . . . . . .
DR101 /DR102 DEVICE DESCRIPTION PART NO.
Rosco Vision Systems® DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION DV440 WITH DR101 Installation Diagram INSTALLATION 1. 2. 3. 4. 5. 4 Clean the ABS flat surface with an alcoholic wipe and let it dry. Remove the liner from the 3M tape on the bottom of the DR101. Place the device on the flat surface. Route the wire to connect to the RS232 port on the DV457. Please refer to https://wiki.roscocloud.com for a more detailed instruction.
DR101 /DR102 DV440 WITH DR101 Installation Diagram Cont.
Rosco Vision Systems® DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION DV440 WITH DR101 Driver ID Reader/Writer Operating with DVXC4 • • • When the installation is completed, turn on the DVXC4. Swipe an applicable ID card/tag on the surface of the device. A successful swipe yields 1 beep, a card failure yields 3 beeps. If a card/tag is not scanned 90 seconds after the DVXC4 turns on, then an audible alert will activate on the DVXC4.
DR101 /DR102 DEVICE TECHNICAL SPECIFICATIONS DR101/ DR102 Dimensions W x H x D: Weight: Cable Length: DR101: DR102: Voltage Input: Operation Distance: Interface Level: Interface Level: Operating Environment: Temperature: Relative Humidity: Storage Environment: Temperature: Relative Humidity: 61 x 80 x 26 mm 150g 3m 1m +/- 5V DC 3 cm Standard RS232 Signal Level RS232 Connection: Micro-Fit 3.
Rosco Vision Systems® DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION Certification FCC ID: 2AEDLDR1002020 IC: 25914-DR1002020 FCC STATEMENT Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and; (2) This device must accept any interference received, including interference that may cause undesired operation.
DR101 /DR102 NOTES 9
A CENTURY OF AUTOMOTIVE VISION SAFETY 90-21 144th Place, Jamaica, New York 11435 TEL (800) 227-2095• FAX (718) 297-0323 techsupport@roscovision.com www.roscomirrors.com www.roscovision.com Lit P/N: MNLDR101102 Lit. Revision: 1.41 Lit.