User's Manual

ManualsBrandsRONDISH ManualsElectronicsWireless Call Point Transmitter

WCP-21 User Manual

Version: 0.1

Date: 2019-02-19

Page: 1 | 4

RONDISH PROPERTY and CONFIDENTIA

1. Make sure the unit is power up with 2x CR2477 inserted

2. If batteries have been installed, it should be put into storage mode by default.

Exit the Storage Mode

3. Programming WCP-21

i) Press and hold the "Call" button.

ii) LED will flash about 10 seconds and then off.

User ID Programming:

Refer to “WCP-21 UID Programming.pdf” to program the user ID. And program it to:

ZZ AA S: 01 01 0

P LL G: 30 10

TFFRRUBB 03 01 00 10

4. Learning the WCP-21 to MCL-01

a. Power on MCL-01 and WCP-21

b. Put the mode switch on MCL-01 back side to “1”

Summary of content (4 pages)

PAGE 1
WCP-21 User Manual Version: 0.1 Date: 2019-02-19 Page: 1|4 1. Make sure the unit is power up with 2x CR2477 inserted 2. If batteries have been installed, it should be put into storage mode by default. Exit the Storage Mode 3. Programming WCP-21 i) Press and hold the "Call" button. ii) LED will flash about 10 seconds and then off. User ID Programming: Refer to “WCP-21 UID Programming.pdf” to program the user ID. And program it to: ZZ AA S: 01 01 0 P LL G: 30 10 TFFRRUBB 03 01 00 10 4.
PAGE 2
WCP-21 User Manual Version: 0.1 Date: 2019-02-19 Page: 2|4 c. Place the magnet on MCL-01 blue point reed-switch position When MCL beeps 2 sounds, remove the magnet d. e. f. g. Place the magnet on WCP-21 reset reed-switch position. WCP-21 LED will flash slowly Then LED will become flash rapidly. Remove the magnet at this moment Wait until MCL will beep a sound and WCP-21 LED will stop flashing Place the magnet on the MCL-01 blue point reed-switch position. Remove the magnet MCL beeps 2 sounds.
PAGE 3
WCP-21 User Manual Version: 0.1 Date: 2019-02-19 Page: 3|4 i. ii. iii. iv. Press the “call” button, WCP-11 led will flash and have a beep sound MCL will light up Press the “reset” button, MCL will light off b. Cord-string test: Procedure: i. Pull the cord-string, ii. WCP-11 led will flash and have a beep sound iii. MCL will light up iv. Press the “reset” button, MCL will light off c. Magnet reset test: Procedure: i. Press the “call” button, ii. WCP-11 led will flash and have a beep sound iii.
PAGE 4
WCP-21 User Manual Version: 0.1 Date: 2019-02-19 Page: 4|4 FCC/CE Statement FCC Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.