UI TL-2100GR V.01C RONDISH Cordless Bed Monitoring System USER INSTRUCTION Important: Changes or modification to this product that is not authorized by the manufacturer could void the FCC compliance and negate your authority to operate the product. Issued 28th Aug.
CONTENTS 1. EQUIPMENT OVERVIEW 2. FEATURES FUNCTIONS AND SETTING UP INSTRUCTIONS 3.
1.0 EQUIPMENT OVERVIEW Providing the ultimate in convenience and ease of use, the Rondish cordless pad monitor requires no cable to connect the Cordless pad with it’s pad monitor. Communication between the Cordless pad that is placed under the sheets and the associated pad monitor is by low power coded digital wireless. The Cordless pad features connection with a low power wireless Transmitter Insert that is fitted and enclosed inside a special pocket with stud fasteners.
automatically detected, an alert will be triggered at the monitor with a single “beep” sound being emitted at regular intervals, accompanied by flash of the monitor “Reset” button light (found on the front panel). In this event, the battery should be replaced immediately. If preferred and for secure operation, this Cordless pad monitor may be simultaneously powered from a 9Vdc regulated ac mains adaptor by connection via the 9V dc power socket provided.
2.1.5 Cordless Pad Monitor signal monitoring and alert indications. Two LED lights are located in the front panel of the Cordless pad monitor unit. On the left hand side the “Check Pad” LED indicates if the signal is lost from the associated pressure pad transmitter. Regular checking signals are automatically transmitted at 25 second intervals from the associated cordless pad.
TRANSMITTER INSERT MODULE (a) Insert 9V battery into the cordless pad monitor unit. (b) Press and release monitor program button found inside the battery compartment. Note that the monitor will "beep" 3 times to indicate in "programming mode" and it's front panel "Status/In Use" light is on. After a period of 30 seconds and with no further activity, the Monitor will automatically exit “programming mode”.
3.0 TECHNICAL SPECIFICATIONS 3.1 Cordless bed monitor Electrical 3.1.1 Power: 9Vdc. PP3 battery and/or 9Vdc regulated ac mains adaptor. 3.1.2 Visual Alarm: Blue LED inside front panel reset button. 3.1.3 Audible Alarm: Selectable sounds with level adjust inside battery cover. 3.1.4 Alarm Interconnect: Volt free relay contact output via ¼” jack socket. 3.1.5 Pressure Pad Connection: Digital wireless (cordless), or cable via RJ11 four pin socket. 3.1.