User's Manual

ManualsBrandsRONDISH ManualsElectronicsCentral Monitor Display

Central Monitor Display (CMD-11c) User Instructions, Version 1

Page 1 of 4

The Rondish Central Monitor Display by Rondish is an affordable fall management and nurse call solution

for a small home or hospital ward. Caregivers can conveniently read a large LED display from a distance,

and the panel will forward signals to a Caregiver Alert Pager that will display call type and device ID.

Straightforward programming allows users to quickly set up the system, and easily add or remove

devices based on changes in daily requirements.

1. Set-Up

Open battery case and inert 6 x AA alkaline batteries. Batteries are intended in case of power loss only,

and will give approximately 4 hours of operation. The product must be connected to a power supply for

normal operation.

Screw on antenna to improve the range of wireless devices

Adjust volume to desired level by using the wheel on the right side. Tracking should only be ON if mobile

devices (wheelchairs or pendant call buttons) will be used. Otherwise set this switch to OFF.

Program devices and settings (see programming section for details)

• Assign a site code if other 433MHz devices will be used nearby, and turn off call forwarding for

any additional panels.

• Add wireless devices to memory as needed

If necessary, activate the lock on the right side to deactivate buttons on face of display. This will lock the

programming and disable the ability to reset alarms at the panel.

Place display on a desk or mount on the wall in a clearly visible location

Summary of content (4 pages)

PAGE 1
Central Monitor Display (CMD-11c) User Instructions, Version 1 The Rondish Central Monitor Display by Rondish is an affordable fall management and nurse call solution for a small home or hospital ward. Caregivers can conveniently read a large LED display from a distance, and the panel will forward signals to a Caregiver Alert Pager that will display call type and device ID.
PAGE 2
Central Monitor Display (CMD-11c) User Instructions, Version 1 2. Operation The CMD-11 will only accept most* alarm signals from devices that have been entered into memory. For instructions on how to add/delete devices go to the next section. The Power Indication LED will be steady ON when connected to a power supply. It will flash if the display is using battery power, and a beep will sound after AC is lost. The Panel Bat LED indicates the status of the panel only.
PAGE 3
Central Monitor Display (CMD-11c) User Instructions, Version 1 3. Programming To enter/exit programming mode, press and hold the Program button for ~5s. The display will beep once and continue flash “PP” when programming has been entered. The display will flash “FF” when programming has finished. Use the Select1 button to adjust the tens-digit, and Select2 to adjust the ones-digit to choose a memory slot.
PAGE 4
Central Monitor Display (CMD-11c) User Instructions, Version 1 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.