Quick Start Guide

This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
STATEMENT REGARDING FCC/ISED COMPLIANCE
REGULATORY COMPLIANCE
Do not dispose of in general waste.
Please recycle batteries and damaged
electrical products appropriately.
FCC ID: 2AGGZMT020401007
IC: 21769-MT020401007
Rollease Acmeda declares this equipment is in compliance with the essential
requirements and other relevant provisions of the following directives:
2014/35/EU - The Low Voltage Directive
2014/30/EU - The Electromagnetic Compatibility Directive
2014/53/EU - The Radio Equipment Directive
Plug USB power adapter into a power outlet.
Plug the ARC Repeater into the USB power adapter.
A blue LED on the ARC Repeater will be visible
when the power is switched on.
Only use Rollease Acmeda USB power adapters with ARC Repeater.
Using other power adapters/power sources may adversely affect ARC
Repeater performance and should be avoided.
ARC Repeater is plug and play. No setup required.
Press any button on a Rollease Acmeda remote
control. The blue light on the ARC Repeater will
flash 3 times. This means the ARC Repeater is
transmitting the signal.
ARC REPEATER
Product #: MT02-0401-069007
QUICK START GUIDE
rolleaseacmeda.com
1
2
3
WARNING
NOTE
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
Maximum of 2 ARC Repeaters can be used in one project
Don’t cover the ARC Repeater with a metal shield
LED LIGHT
IMPORTANT
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
(in 90° orientation)