Safety Instructions

1, This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
2, Children shall not play with the appliance.
3, Cleaning and user maintenance shall not be made by children without supervision.
4, If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
5, WARNING: the drive shall be disconnected from its power source during cleaning,
maintenance and when replacing parts.
6, LpA ≤ 70 dB(A).
7, The mass and the dimension of the driven part shall be compatible with the rated
torque and rated operating time.
8, The type of driven part the drive is intended for.
9, WARNING: Important safety instructions. It is important for the safety of persons
to follow these instructions. Save these instructions.
10, Do not allow children to play with fixed controls. Keep remote controls away
from children.
11, Frequently examine the installation for imbalance and signs of wear or damage
to cables and springs. Do not use if repair or adjustment is necessary.
12, Watch the moving shutter and keep people away until he shutter is completely
closed.
13, WARNING: Important safety instructions. Follow all instructions, since incorrect
installation can lead to severe injury.
14, Before installing the drive, remove any unnecessary cords and disable any
equipment not needed for powered operation.
SAFETY NOTE
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of
this device could void the user’s authority to operate the device.
IC ：
-English:
This device complies with Industry Canada RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference,including interference that may cause undesired operation
of the device.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
-French:
Leprésent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio
Exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, meme si le brouillage est susceptible d'en
compromettre le fonctionnement."