User's Manual

Important Safety Instructions
(1) Read these instructions.
(2) Keep these instructions.
(3) Heed all warnings.
(4) Follow all instructions.
(5) Do not use this apparatus near water.
(6) Clean only with dry cloth.
(7) Do not block any ventilation openings. Install in accordance with
the manufacturer’s instructions.
(8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
(9) Only use attachments/accessories specified by the manufacturer.
(10) Unplug this apparatus during lightning storms or when unused
for long periods of time.
(11) Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation
No changes shall be made to the equipment without the
manufacturer’s permission as this may void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This device complies with the FCC safety requirements for RF exposure
in accordance with FCC rule part §2.1093
Industry Canada Statement
“This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device”
This device complies with the safety requirement for RF exposure
in accordance with RSS-102, issue 5 for portable conditions.
Pour les usagers résidant au Canada
Le présent appareil est conforme aux CNR du ISDE applicables aux
appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Cet appareil est conforme aux limites d’exposition humaine aux
radiofréquences pour les ordinateurs portables, conformément
au CNR 102, 5ème édition
Europe (R&TTE Directive)
Declaration of Conformity to R&TTE Directive, 1999/5/EC:
Hereby, ROLI Ltd, declares that this Lightpad Block, Live Block, & Loop
Block is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
ROLI Ltd, vakuuttaa täten että Lightpad Block, Live Block & Loop Block
tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä
koskevien direktiivin muiden ehtojen mukainen.
Important Information
001486 BLOCKS LIGHTPAD REGULATORY INFO (EMEA, CANADA) Rev 002.indd 1
Seaboard
Seaboard Block